Thesis (M. Tech. - Engineering: Electrical, Department Electronic Engineering, Faculty of Engineering and Technology)--Vaal University of Technology. / Curing of materials in order to obtain different properties has been a practice for many years.
New developments in composite materials increase the need to control certain variables
during the curing process. One very significant variable is temperature. Temperature control
by itself is an old practice, however when the need for repeatedly controlling the process
accurately over long periods of time arises, a system is required that outperforms normal
manual control.
One of the aspects within such a system that needs to be considered is the ability to
replicate the temperatures within an oven which were originally used for a specific material’s
curing profile. This means that a curing profile would need to be defined, saved for later and
finally be interpreted correctly by the controlling system.
Different control methods were simulated to enable the system to control the temperature
which has been defined by literature. This dissertation introduces a variation on the
standard control methods and shows improved results.
Switching the oven on and off in order to increase or decrease internal oven temperature
seems simple, but can cause switching devices to decrease their operational life span, if not
designed carefully. A combination switch was introduced which harnesses the advantages
of two very common switching devices to form an improved combination switch.
Software for the personal computer environment, as well as software for the embedded
environment were developed and formed a control system that produced acceptable results
for temperature control. Accuracies of 98% and more were achieved and found to be
acceptable according to standard engineering control practices.
An accurate temperature profile controller was designed, simulated and built in order to
control the temperature inside a specific curing oven which, in turn, determined the curing
properties of specific materials. The overall results were satisfactory which lead to achieving
the objectives outlined in this dissertation.
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:vut/oai:digiresearch.vut.ac.za:10352/112 |
| Date | 12 1900 |
| Creators | Schoeman, Ruaan Mornè |
| Contributors | Janse van Rensburg, J. F. |
| Source Sets | South African National ETD Portal |
| Language | English |
| Detected Language | English |
| Type | Thesis |
| Format | xi, 88 leaves, diagr. |
| Relation | PDF. Adobe Acrobat Reader, version 8.1 |
Page generated in 0.0018 seconds