Mechanical factors have been cited as a primary cause of total knee replacement failure. A hypothesis has been formulated stating that the introduction of a compliant interface into a total knee prosthesis would moderate excessive stresses and strains, thereby, extending joint life. A biocompatable elastomer developed by the Dow Corning Corporation was selected for mechanical evaluation as a cushioning material. Force-strain, impact, and fatigue tests were conducted on several specially designed and fabricated elastomer test shapes. Test results demonstrate that a suitably stiff and dynamically responsive elastomer cushion can be designed to handle repeated physiological knee joint loads. Physiological impacts with cadaver tibias demonstrated significant shock reduction benefits, including peak force reductions of up to 70%, with the addition of different elastomer shapes. Compressive fatigue evaluation of elastomer samples was inconclusive owing to extensive sample wear. As a result configurations or applications where the elastomer can move relative to a rigid surface are not recommended. A new, mechanically contained elastomer shape was designed and tested which greatly reduced wear. Bonding of this new shape to prosthetic joint materials is recommended for further experimental evaluation. / Thesis / Master of Engineering (ME)
| Identifer | oai:union.ndltd.org:mcmaster.ca/oai:macsphere.mcmaster.ca:11375/24477 |
| Date | 05 1900 |
| Creators | Kelly, Brian |
| Contributors | Newcombe, W. R., Repo, R. U., Mechanical Engineering |
| Source Sets | McMaster University |
| Language | English |
| Detected Language | English |
| Type | Thesis |
Page generated in 0.0022 seconds