A novel electromechanical brake (EMB) based on the eddy current principle is proposed for application in electrical vehicles. The proposed solution is a feasible replacement for the current conventional hydraulic brake (CHB) systems. Unlike CHBs eddy current brakes (ECBs) use eddy currents and their interaction with an externally applied magnetic field to generate braking torque. Due to their pure electrically controllable and contact free nature, ECBs have multiple advantages over the current CHB systems, such as faster response, reduced weight and number of components, ease of implementing various controllers (e.g., anti-lock braking), and reduced noise levels. However, the torque generated by a typical ECB at low speeds is insufficient to effectively and completely stop a moving vehicle. Therefore, an ECB is commonly used as an assistive brake to the CHB system in heavy vehicles, i.e. trains and trucks In order to overcome this shortcoming, the use of AC magnetic fields is proposed to realize a stand-alone ECB system in which sufficient braking torque can be generated at low speeds. To this end, eddy currents are modeled analytically using the governing Maxwell’s equations with the consideration of time varying field application. The analytical model was validated using finite element analysis. Results show that the braking torque increases with the application of a time varying field.
Various forms of time varying fields have been studied. It was found that the
frequency-modulated applied field in triangular waveform results in the highest braking torque. Next, the design was optimized to maximize the braking torque and an optimum configuration was obtained using multiple pole projection areas (PPAs). Optimization results show that the braking torque significantly increases with the introduction of additional PPAs to the configuration, and the braking torque generation for an optimum four-PPA ECB configuration exceeds the braking requirements for current passenger
vehicles.
For control purposes, a dynamic model for a novel stand-alone ECB system using AC fields for automotive applications has been successfully designed and evaluated. Also, a model-based predictive controller has been developed for the optimum ECB
configuration. Finally an experimental test-bed has been designed for experimentation of both DC and AC field application on ECB. / Graduate
| Identifer | oai:union.ndltd.org:uvic.ca/oai:dspace.library.uvic.ca:1828/4289 |
| Date | 21 September 2012 |
| Creators | Karakoc, Kerem |
| Contributors | Suleman, Afzal, Park, Edward Jung Wook |
| Source Sets | University of Victoria |
| Language | English, English |
| Detected Language | English |
| Type | Thesis |
| Rights | Available to the World Wide Web |
Page generated in 0.0021 seconds