Terrestrial laser scanning (TLS) may provide a way to increase timber value recovery by replacing manual timber cruising with a simple-to-use, cost-effective alternative. TLS has been studied in several trials worldwide. Past studies have not compared TLS based estimates with mill estimates of stem value and volume.
Three differently stocked stands of hybrid poplar were selected for diameter, stem sinuosity and height measurement using manual cruising and TLS. Selected trees were harvested and transported to a mill where they were scanned and then processed into lumber and chips. Data gathered using both manual and TLS methods were used to obtain stem volume and value estimates to compare with mill estimates.
Results indicated that TLS diameter measurements were more accurately matched to mill and manual measurements up to about 7.5 meters on the stem than above 7.5 meters on the stem in all three stands. Stem curvature comparisons indicated that the variation between TLS and mill centerline measurements was similar to the variation between repeat mill scan measurements of the same stems.
Using TLS as a pre-harvest inventory tool showed that additional revenue could be obtained from the reallocation of saw-log and chip log volume to veneer logs of various sizes in all three stands. It was also shown that the sampling error required to estimate stand value was greater than was required to estimate stand volume within the same error limits. / Graduation date: 2012
| Identifer | oai:union.ndltd.org:ORGSU/oai:ir.library.oregonstate.edu:1957/30216 |
| Date | 25 May 2012 |
| Creators | Barnett, Jennifer S. |
| Contributors | Murphy, Glen |
| Source Sets | Oregon State University |
| Language | en_US |
| Detected Language | English |
| Type | Thesis/Dissertation |
Page generated in 0.0011 seconds