Transverse mode control of a vertical-cavity surface-emitting laser (VCSEL) is achieved by spatially filtered optical feedback. The spatial filter consisted of a pinhole, either 42 pm or 81 pm, in the 5.8x magnified VCSEL image plane of a confocal lens arrangement. The pinhole was translated to map out the voltage drop across the VCSEL from spatially-selective feedback. For low injection currents, spatially filtered feedback enabled single fundamental mode operation due to higher-order mode suppression by appropriately locating the pinhole. For higher injection currents with five laser modes, spatial selection of feedback enabled control of the relative mode intensities and wavelengths. The maximum increase in mode intensity achieved was 1.8x for the 42 pm pinhole and 2.-1 . for the 81 µm pinhole. The maximum frequency shift achieved was -2.7 GHz and -7.1 GHz with the 42 p.m and the 81 pm pinholes. The spatially-selective optical feedback produced long-lived changes to the VCSEL even after the feedback was blocked - results for two separate trials where the recovery time was 38 minutes are presented (although results varied for different bias and feedback conditions).
Identifer | oai:union.ndltd.org:uvic.ca/oai:dspace.library.uvic.ca:1828/2850 |
Date | 14 June 2010 |
Creators | Cha, Mei Ting |
Contributors | Gordon, Reuven |
Source Sets | University of Victoria |
Language | English, English |
Detected Language | English |
Type | Thesis |
Rights | Available to the World Wide Web |
Page generated in 0.0014 seconds