Reliability is one of the important issues of recent microprocessor design. Processors must provide correct behavior as users expect, and must not fail at any time. However, unreliable operation can be caused by excessive supply voltage fluctuations due to an inductive part in a microprocessor power distribution network. This voltage fluctuation issue is referred to as inductive or di/dt noise, and requires thorough analysis and sophisticated design solutions. This dissertation proposes an automated stressmark generation framework to characterize di/dt noise effect, and suggests a practical solution for management of di/dt effects while achieving performance and energy goals. First, the di/dt noise issue is analyzed from theory to a practical view. Inductance is a parasitic part in power distribution network for microprocessor, and its characteristics such as resonant frequencies are reviewed. Then, it is shown that supply voltage fluctuation from resonant behavior is much harmful than single event voltage fluctuations. Voltage fluctuations caused by standard benchmarks such as SPEC CPU2006, PARSEC, Linpack, etc. are studied. Next, an AUtomated DI/dT stressmark generation framework, referred to as AUDIT, is proposed to identify maximum voltage droop in a microprocessor power distribution network. The di/dt stressmark generated from AUDIT framework is an instruction sequence, which draws periodic high and low current pulses that maximize voltage fluctuations including voltage droops. AUDIT uses a Genetic Algorithm in scheduling and optimizing candidate instruction sequences to create a maximum voltage droop. In addition, AUDIT provides with both simulation and hardware measurement methods for finding maximum voltage droops in different design and verification stages of a processor. Failure points in hardware due to voltage droops are analyzed. Finally, a hardware technique, floating-point (FP) issue throttling, is examined, which provides a reduction in worst case voltage droop. This dissertation shows the impact of floating point throttling on voltage droop, and translates this reduction in voltage droop to an increase in operating frequency because additional guardband is no longer required to guard against droops resulting from heavy floating point usage. This dissertation presents two techniques to dynamically determine when to tradeoff FP throughput for reduced voltage margin and increased frequency. These techniques can work in software level without any modification of existing hardware. / text
| Identifer | oai:union.ndltd.org:UTEXAS/oai:repositories.lib.utexas.edu:2152/25185 |
| Date | 14 July 2014 |
| Creators | Kim, Youngtaek |
| Source Sets | University of Texas |
| Detected Language | English |
| Type | Thesis |
| Format | application/pdf |
Page generated in 0.0019 seconds