Power Factor Correction rectifiers are widely adopted as the first stage in most grid-tied power conversion systems. Among all PFC converts for single phase system, Boost PFC is the most popular one due to simplicity of structure and high performance. Although the efficiency of Boost PFC keeps increasing with the evolution of semiconductor technology, the intrinsic feature of high output voltage may result cumbersome system structure with multiple power conversion stages and even diminished system efficiency. This disadvantage is aggravated especially in systems where resonant converters are selected as second stage.
Especially for domestic induction cooker application, step-down PFC with wide range output regulation capability would be a reasonable solution, Conventional induction cooker is composed by input filter, diode-bridge rectifier, and full bridge or half bridge series resonant circuit (SRC). High frequency magnetic field is induced through the switching action to heat the pan. The power level is usually controlled through pulse frequency modulation (PFM). In such configuration, first, a bulky input differential filter is required to filter out the high frequency operating current in SRC. Second, as the output power decreases, the operating point of SRC is moved away from the optimum point, which would result large amount circulating energy. Third, when the pan is made of well conducting and non-ferromagnetic material such as aluminum, due to the heating resistance become much smaller and peak output voltage of the switching bridge equals to the peak voltage of the grid, operating the SRC at the series resonant frequency can result excessive current flowing through the switch and the heating coil. Thus for pan with smaller heating resistance, even at maximum power, the operating frequency is pushed further away from the series resonant point, which also results efficiency loss.
To address these potential issues, a PFC circuit features continuous conducting input current, high power factor, step-down capability and wide range output regulation would be preferred. The Analysis and design work is present in this article for a non-isolated hard switching DCM SEPIC PFC. Due to DCM operation of SPEIC converter, wide adjustable step-down output voltage, continuous conduction of input current and elimination of reverse recovery loss can be achieved at same time.
The thesis begins with circuit operation analysis for both DC-DC and PFC operation. Based on averaged switching model, small signal model and corresponding transfer functions are derived. Especially, the impact from small intermediate capacitor on steady state value are discussed.
With the concept of ripple steering, theoretic analysis is applied to SEPIC converter with two coupled inductors. The results indicate if the coupling coefficient is well designed, the equivalent input inductance can be multiple times larger than the self-inductance. Because of this, while maintaining input current ripple same, the two inductors of SEPIC can be implemented with two smaller coupled inductors. Thus both the total volume of inductors and the total number of windings can be reduced, and the power density and efficiency can be improved. Based on magnetic reluctance model, a corresponding winding scheme to control the coupling coefficient between two coupled inductors is analyzed. Also the impact of coupled inductors on the small signal transfer function is discussed.
For the voltage follower control scheme of DCM PFC, single loop controller and notch filter design are discussed. With properly designed notch filter or the PR controller in another word, the closed loop bandwidth can be increased; simple PI controller is sufficient to achieve high power factor; THD of the input current can be greatly reduced.
Finally, to validate the analysis and design procedure, a 1 kW prototype is built. With 120 Vrms AC input, 60V to 100V output, experimental results demonstrate unity power factor, wide output voltage regulation can be achieved within a single stage, and the 1 kW efficiency is around 93%. / Master of Science
| Identifer | oai:union.ndltd.org:VTETD/oai:vtechworks.lib.vt.edu:10919/51664 |
| Date | 31 March 2015 |
| Creators | Chen, Rui |
| Contributors | Electrical and Computer Engineering, Lai, Jih-Sheng, Ha, Dong S., Ngo, Khai D. |
| Publisher | Virginia Tech |
| Source Sets | Virginia Tech Theses and Dissertation |
| Detected Language | English |
| Type | Thesis |
| Format | ETD, application/pdf |
| Rights | In Copyright, http://rightsstatements.org/vocab/InC/1.0/ |
Page generated in 0.0021 seconds