Many different stormwater control measures (SCMs) can be implemented in order to mitigate issues with polluted stormwater flows into receiving water bodies. The treatment function of SCMs is commonly based on the removal of particles by sedimentation, thereby also removing pollutants associated with particles. In recent years, more attention has been given to characterizing and understanding of different particle size fractions and their association with pollutants commonly found in stormwater. It has become increasingly clear that the smaller sized particles are very important pollutant transporters and should be considered when designing and implementing SCMs. However, the settling velocities for smaller sized particles are very low and may not be effectively removed in existing SCMs. One treatment process with a proven ability to enhance sedimentation is coagulation/flocculation, widespread in water and wastewater treatment, but with very few accounts of it being used in a stormwater context. This thesis aims to investigate the treatability of stormwater with a coagulation/flocculation process. This includes the determination of operating conditions, the dominating coagulation mechanism and the reduction efficiency of stormwater related pollutants. The objectives of the thesis were achieved in laboratory tests treating stormwater in a jar-testing procedure. An initial screening of primary coagulants and flocculant aids was conducted using an urban snowmelt mixture. Five of the chemicals were then selected for an extended testing regime which was setup up to determine the operating conditions where maximal turbidity reduction was attained by measuring the pH, conductivity, alkalinity and zeta-potential over the tested doses for each coagulant. Criteria used for chemical selection included high turbidity reduction, low dose requirement and low pH/alkalinity impacts. Charge reversal was observed at positive zeta-potential indicating that the dominating coagulation mechanism was charge neutralization. The content of turbidity/total suspended solids, total organic carbon, total metals and hydrocarbons by >90%. Dissolved copper was reduced by 40% on average, and the reduction rates for dissolved zinc were varying with up to a 300% increase, presumably due to changes in pH, leading to a higher mobility. Changes in the particle size distribution after coagulation/flocculation as compared to sedimentation indicated an effect on the size fraction corresponding to smaller particles. The performance of the coagulation/flocculation process was also tested on road runoff collected from a central road in Luleå with a high traffic intensity. Two coagulants were tested, iron chloride and pre-hydrolyzed aluminum chloride. Reduction rates for the total metal fraction were >90% on average for both coagulants, but for the dissolved metal fractions differences could be observed between the coagulants with the iron chloride resulting in higher reductions for dissolved chrome (57% compared to 34%) and copper (47% compared to 30%). Both products increased the dissolved fractions of nickel and zinc due to lower final pH.
| Identifer | oai:union.ndltd.org:UPSALLA1/oai:DiVA.org:ltu-73091 |
| Date | January 2019 |
| Creators | Nyström, Fredrik |
| Publisher | Luleå tekniska universitet, Arkitektur och vatten, Luleå |
| Source Sets | DiVA Archive at Upsalla University |
| Language | English |
| Detected Language | English |
| Type | Licentiate thesis, comprehensive summary, info:eu-repo/semantics/masterThesis, text |
| Format | application/pdf |
| Rights | info:eu-repo/semantics/openAccess |
| Relation | Licentiate thesis / Luleå University of Technology, 1402-1757 |
Page generated in 0.0024 seconds