Results from a research program to investigate the long term effects of
through-the-thickness fastener clamp-up force (preload) relaxation on the
strength of mechanically fastened joints for two graphite/thermoplastic
composite materials (Dupont's IM6/KIII and ICI-Fiberite's IM8/APC(HTA)) are
summarized and compared with analytical methods. An experimental program
was conducted in which 56 mechanically fastened single-shear joints were
tested. Phase I static tests established joint bearing strength as a function of
clamp-up force for two types of fasteners (protruding head and countersink) with
no relaxation of preload. Phase II testing monitored short-term fastener preload
relaxation (up to 1 ,000 hours), with special bolt force sensor washers. Inservice
parameters included were temperature, in-plane loads, and torque. The
jOints were tested to failure at the end of the relaxation time period to determine
any subsequent effect on joint strength.
Phase I test results indicated that joint bearing strength increased by as
much as twenty-eight percent over the clamp-up force range of a Ibs (fingertight)
to 3,500 Ibs for both materials. Fastener head type, material, and
temperature also affected the resultant bearing strength. For Phase II, fastener
clamp-up force at room temperature (78°F) relaxed an average of six percent
from the initial value during the short-term test period. The relaxation was
projected to be as high as fourteen and sixteen percent at 100,000 hours for
HTA and Kill, respectively. The elevated temperature condition (250°F)
significantly increased the relaxation rate with the projected 100,000 hour
relaxation amount being as high as thirty-seven percent for HTA and sixty
percent for Kill. Comparison of the Phase II bearing strengths to the Phase I
results indicated that portions of the data correlated well, while others did not. It
was concluded that relaxation of the clamp-up force over the short-term time
period did not significantly lower the bearing strength of either material,
however an extended exposure to 250°F could affect the bearing strength. / Thesis (M.S.)--Wichita State University, College of Engineering, Dept. of Aerospace Engineering.
| Identifer | oai:union.ndltd.org:WICHITA/oai:soar.wichita.edu:10057/3988 |
| Date | 12 1900 |
| Creators | Schmitt, Ron R. |
| Contributors | Horn, Walter J. |
| Publisher | Wichita State University |
| Source Sets | Wichita State University |
| Language | en_US |
| Detected Language | English |
| Type | Thesis |
| Format | xx, 217 p. |
| Rights | Copyright Ron R. Schmitt, 1991. All rights reserved |
Page generated in 0.0021 seconds