In the world there are adverse climates, climates that hinder the good construction and paving of roads, generating insecurity among the locals and visitors. This over time affects the economy of a country, as a road boosts tourism, transport and commerce. Therefore, a mixture was designed to mitigate a problem in the placement of hot asphalt mixture at temperatures below zero degrees Celsius. That is, a conventional mix design was proposed, but with different types of filler (lime, Portland cement type I and silica) tested with the Marshall and Lottman method which are governed according to the EG-2013 standards [1] and parameters established in the Asphalt Institute [2]. To find the optimum, it was tested with 5.0%, 5.5% 6.0% and 6.5% asphalt cement. Then with the results obtained a comparative analysis was performed. Finally, specimens without any additives were made, the specimens once prepared at 140°C were subjected to freezing, resulting in the three types of filler, that the hot asphalt mixture with incorporation of Portland cement type I to a 5, 90% of asphalt cement is the optimum since, subject to extreme temperatures below 0°C they comply with the parameters required in the standards.
| Identifer | oai:union.ndltd.org:PERUUPC/oai:repositorioacademico.upc.edu.pe:10757/651795 |
| Date | 28 February 2020 |
| Creators | Chávez, H., Chávez, H., Pezo, A., Llerena, G., Torres, V. |
| Publisher | Institute of Physics Publishing |
| Source Sets | Universidad Peruana de Ciencias Aplicadas (UPC) |
| Language | English |
| Detected Language | English |
| Type | info:eu-repo/semantics/article |
| Format | application/pdf |
| Rights | info:eu-repo/semantics/openAccess, Attribution-NonCommercial-ShareAlike 4.0 International, http://creativecommons.org/licenses/by-nc-sa/4.0/ |
| Relation | IOP Conference Series: Materials Science and Engineering, 1, https://iopscience.iop.org/article/10.1088/1757-899X/758/1/012059/meta, 758 |
Page generated in 0.0018 seconds