<p>The demand for more accurate measurements is increasing in today’s industry. One reason for this is to optimize production and thus maximize profits. Another reason is that in some cases government regulations dictate that supervision of certain parameters must be followed. At Preemraff Lysekil there are basically four reasons for measuring skin temperatures inside fired process heaters, namely; because of government regulations, in order to estimate the load of the fired process heater, to estimate the lifetime of the tubes inside the fired process heater and finally, to determine the need of decoking. However, only the first three of these reasons are applied to H2301/2/3. The current skin thermocouple design has been in use for many years and now the question of how well it measures surface temperature has risen. Furthermore a new weld-free design is under consideration to replace the old skin thermocouple design. Another question is therefore how well the new design can measure the surface temperature under the same operating conditions as the old one. In order to evaluate this, three–dimensional computer simulations were made of the different designs. As this thesis will show, the differences in calculated skin thermocouple temperature and calculated surface temperature is about the same for the two designs. However, the current design will show a lower temperature than the surface temperature, while the new design will show a higher temperature. Regarding the core of the skin thermocouple designs, namely the thermocouple, no hard conclusions can be drawn, although the industry appears to favor type ’N’ over type ’K’.</p>
| Identifer | oai:union.ndltd.org:UPSALLA/oai:DiVA.org:liu-8519 |
| Date | January 2007 |
| Creators | Lundh, Joel |
| Publisher | Linköping University, Department of Management and Engineering, Institutionen för ekonomisk och industriell utveckling |
| Source Sets | DiVA Archive at Upsalla University |
| Language | English |
| Detected Language | English |
| Type | Student thesis, text |
Page generated in 0.0021 seconds