Synthetic membranes have a high separation efficiency, small footprint, low energy consumption and ease of operation, making them an attractive alternative to traditional separation operations. For this reason, membranes have been extensively studied for the treatment and recycling of bitumen-containing wastewaters. Such wastewaters include petroleum produced water, residual pipeline cleaning solutions and contaminated water from oil spills. Ceramic membranes are preferred in these applications over polymeric membranes because they are highly resistant to solvents and can be operated at high temperatures over a wide range of pH. Fine clays and silicates, coated with bitumen, are significant foulants for membrane filtration systems. These foulants possess acidic, basic and amphoteric groups, leading to the presence of both positive and negative surface charges. Ceramic membranes in aqueous media have a pH dependent surface charge. It was hypothesized that these surface charges are responsible for the high fouling of ceramic membranes that is observed when treating wastewaters containing bituminous fines.
The overall objective of this research was to reduce fouling and increase the lifetime of ceramic membranes in treating oil sands produced water; an example of a wastewater containing bituminous fines. This goal was achieved through the surface modification of the ceramic membrane’s selective layer, as well as by the implementation of a novel in-place steam regeneration technique. All membrane filtration tests were performed with field samples of oil sands produced water that were supplied to CanmetMINING (NRCan) by three Canadian oil sands companies.
Organosilanes are silicon-based monomers that can possess a wide array of chemical functionality due to their organic moieties. They are capable of reacting with oxide surfaces, and have seen extensive use as surface modification agents for ceramic membranes in various applications. To maintain desirable hydrophilic properties without surface charges, highly hydrophilic and non-ionic polyethylene oxide (PEO) based organosilanes were identified. These PEO-silanes were then used to modify ceramic membranes of several different selective layer materials, and the thermal stability of the silane layer was studied using FTIR, SEM, zeta potential and contact angle measurements. The modification procedure with PEO-silanes was first applied to lab-scale membrane disks, and subsequently to commercial scale multilumen membrane tubes that were tested in a pilot-scale system at CanmetMINING. Results obtained from both sets of experiments were promising and demonstrate that ceramic membranes can be surface modified in a way that successfully renders them fouling resistant to the bituminous fines present in these wastewaters. Upon surface modification, foulants were more readily released from the membrane surface, resulting in an enhanced flux and separation performance.
A novel steam regeneration technique was also applied as a means of bituminous fouling alleviation. This technique was tested in the CanmetMINING pilot-scale system and consisted of periodically injecting steam into the membrane lumen feed channels during operation. Direct steam injection rapidly heated foulant cake layers, and water droplets in the saturated steam caused surface abrasions that ultimately resulted in the scouring of bitumen away from the membrane surface. Membrane fluxes when steam regeneration was active were up to 4 times higher when compared to tests where only traditional permeate backflushing was used.
The fouling remediation techniques developed in this work have broad potential applicability in ceramic membrane filtration systems aimed at treating all wastewaters containing bituminous compounds, such as process waters in general and contaminated water from oil spills.
| Identifer | oai:union.ndltd.org:uottawa.ca/oai:ruor.uottawa.ca:10393/39786 |
| Date | 29 October 2019 |
| Creators | Atallah, Charbel |
| Contributors | Tremblay, André-Yves |
| Publisher | Université d'Ottawa / University of Ottawa |
| Source Sets | Université d’Ottawa |
| Language | English |
| Detected Language | English |
| Type | Thesis |
| Format | application/pdf |
Page generated in 0.0019 seconds