For autonomous mine vehicles that perform the ”load-haul-dump” (LHD) cycle to operate properly, calibration of the sensors they rely on is crucial. The LHD cycle refers to a vehicle that loads material, hauls the material along a route and dumps it in an extraction point. Many of these vehicles are waist-actuated, meaning that the front and rear part of the machines are fixated at an articulation point. The focus of this thesis is about developing and implementing two differ- ent frameworks to distinguish patterns from routes where calibration of the hinge-angle sensor was needed before and try to predict when calibrating the sensor is needed. We present comparative results of one method using ma- chine learning, specifically supervised learning with support vector machine and one optimization-based method using scan matching by implementing a two-dimensional NDT (Normal Distributions Transform) algorithm. Comparative results based on evaluation metrics used in this thesis show that detecting incorrect behaviour of the hinge-angle sensor is possible. Evaluation show that the machine learning classifier performs better on the data used for this thesis than the optimization-based classifier.
| Identifer | oai:union.ndltd.org:UPSALLA1/oai:DiVA.org:oru-84453 |
| Date | January 2020 |
| Creators | Landström, Per, Sandström, John |
| Publisher | Örebro universitet, Institutionen för naturvetenskap och teknik, Örebro universitet, Institutionen för naturvetenskap och teknik |
| Source Sets | DiVA Archive at Upsalla University |
| Language | English |
| Detected Language | English |
| Type | Student thesis, info:eu-repo/semantics/bachelorThesis, text |
| Format | application/pdf |
| Rights | info:eu-repo/semantics/openAccess |
Page generated in 0.0018 seconds