Improved transient performance and converter miniaturization are the major driving factors behind high frequency operation of switching power supplies. However, high speed operation is limited by topology, control, semiconductor, and packaging technologies. The inherent mitigation of switching loss in resonant converters makes them prime candidates for use when the limits of switching frequency are pushed. The goal of this thesis is to address two areas that practically limit the achievable switching frequency of resonant topologies.
Traditional control methods based on single cycle response are impractical at high frequency; forcing the use of pulse density modulation (PDM) techniques. However, existing pulse density modulation strategies for resonant converters in dc/dc applications suffer from:
• High semiconductor current stress.
• Slow response and large filter size determined by the low modulating frequency.
• Possibly operating at fractions of resonant cycles leading to switching loss; thereby limiting the modulating frequency.
A series resonant converter with variable frequency PDM (VF-PDM) with integral resonant cycle control is presented to overcome the limitations of existing PDM techniques to enable efficient operation with high switching frequency and modulating frequency. The operation of the circuit is presented and analyzed, with a design procedure given to achieve fast transient performance, small filter size, and high efficiency across the load range with current stress comparable to conventional control techniques. It is shown that digital implementation of the controller can achieve favourable results with a clock frequency four times greater than the switching frequency.
Driving the synchronous rectifiers is a considerable challenge in high current applications operating at high switching frequency. Resonant gate drivers with continuous inductor current experience excessive conduction loss, while discontinuous current drivers are subject to slow transitions and high peak current. Current source drivers suffer from high component count and increased conduction loss when applied to complementary switches.
A dual-channel current source driver is presented as a means of driving two complementary switches. A single coupled inductor with discontinuous current facilitates low conduction loss by transferring charge between the MOSFET gates to reduce the number of semiconductors in the current path, and reducing the number of conduction intervals. The operation of the circuit is analyzed, and a design procedure based on minimization of the total synchronous rectifier loss is presented. Implementation of the digital logic to control the driver is discussed.
Experimental results at megahertz operating frequencies are presented for both areas addressed to verify the theoretical results. / Thesis (Ph.D, Electrical & Computer Engineering) -- Queen's University, 2012-09-09 20:43:56.997
| Identifer | oai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:OKQ.1974/7452 |
| Date | 10 September 2012 |
| Creators | Tschirhart, Darryl |
| Contributors | Queen's University (Kingston, Ont.). Theses (Queen's University (Kingston, Ont.)) |
| Source Sets | Library and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada |
| Language | English, English |
| Detected Language | English |
| Type | Thesis |
| Rights | This publication is made available by the authority of the copyright owner solely for the purpose of private study and research and may not be copied or reproduced except as permitted by the copyright laws without written authority from the copyright owner. |
| Relation | Canadian theses |
Page generated in 0.002 seconds