Coal is today the fossil fuel which offers the greatest proven reserves. Due to increasingly stringent environmental legislation, coal fired combustion systems should be based on clean coal combustion technologies. For clean and efficient
energy generation from coal reserves, the most suitable technology known to date is the &lsquo / Fluidized Bed Combustion&rsquo / technology. Applications of circulating fluidized bed combustion (CFB) technology have been steadily increasing in both capacity and number over the past decade for the utilization of this resource. Designs of these units have been based on the combustion tests carried out in pilot
scale facilities to determine the combustion and desulfurization characteristics of the coals and limestones in CFB conditions. However, utilization of Turkish lignites with high ash, volatile matter and sulfur contents in CFB boilers
necessitates adaptation of CFB combustion technology to these resources. Therefore, it has been the objective of this study to investigate combustion characteristics of an indigenous lignite in a circulating fluidized bed combustor.
In this study, a 150 kWt Circulating Fluidized Bed (CFB) Combustor Test Unit was designed and constructed in Chemical Engineering Department of Middle East Technical University, based on the extensive experience acquired at the
existing 0.3 MWt Bubbling Atmospheric Fluidized Bed Combustor (AFBC) Test Rig. Following the commissioning tests, combustion tests were carried out for investigation of combustion characteristics of Ç / an lignite in CFB conditions and
for comparison of the design of the test unit with experimental findings.
The steady state results of the combustion tests reveal that Ç / an lignite is fired with high combustion efficiency. Temperature profile along the riser is achieved to be
almost uniform by good control of cooling system. Pressure drop through the dilute zone is found to be negligible because of low solid hold up in this zone. CO and NO concentrations within the flue gas are fairly lower, whereas N2O
concentration is higher compared to the ones obtained in the bubbling AFBC test rig firing the same lignite. The deviation of particle size distributions of bottom ash and circulating ash among the tests are in line with the deviation of superficial
velocity. In order to assess the validity and predictive accuracy of the pressure balance model, it was reapplied to the test unit utilyzing the revised input data based on the results of the combustion tests. Comparison of the model predictions with experimental results revealed that the predictions have acceptable agreement with the measurements. In conclusion, the performance of 150 kW CFBC Test Unit was found to be satisfactory to be utilized for the long term research studies on combustion and desulfurization characteristics of indigenous lignite reserves in
circulating fluidized bed combustors.
| Identifer | oai:union.ndltd.org:METU/oai:etd.lib.metu.edu.tr:http://etd.lib.metu.edu.tr/upload/12609432/index.pdf |
| Date | 01 April 2008 |
| Creators | Batu, Aykan |
| Contributors | Selcuk, Nevin |
| Publisher | METU |
| Source Sets | Middle East Technical Univ. |
| Language | English |
| Detected Language | English |
| Type | Ph.D. Thesis |
| Format | text/pdf |
| Rights | To liberate the content for public access |
Page generated in 0.0022 seconds