The goal of this thesis is to experimentally characterize the flyability of current generation read/write heads over media patterned to densities above the superparamagnetic limit.
The superparamagnetic limit is the physical limit to magnetic storage density. In magnetic storage, superparamagnetism is the uncontrollable switching of stored bits during the lifespan of a hard disk. Theoretical analysis has predicted that densities of ~50 Gbit/in2 are not possible using traditional continuous media. One strategy to achieve high storage density, above the superparamagnetic limit, is patterned media. With patterned media the physical separation of magnetic domains increases their stability.
One of the major challenges of development of patterned media is achieving acceptable flyability of the read/write head. In that vein, a test stand is built to measure head liftoff speed, head to disk intermittent contact and head fly height. Tangential friction, an indicator of head liftoff is measured by a Wheatstone bridge strain circuit attached to a cantilever beam. Intermittent contact is quantified by the amount of noise emanating from the interface, which is measured by a high frequency acoustic emission sensor. Head fly height is measured indirectly with a capacitance circuit built around the head to disk interface.
Experimental samples of current generation read/write heads and media are obtained from industry. Current generation media is patterned using focused ion beam milling to a density of 10 Gbit/in2. Other, extremely dense samples, above 700 Gbit/in2, are created via thin film self assembly on silicon substrate.
Conclusions on slider head flyability over patterned media are based on comparison with flyability over non-patterned media. It is demonstrated that loss of hydrodynamic lubrication is small for small pattern regions with high conserved surface area ratio. Conserved surface area ratio is defined as total surface area minus etched surface area all divided by the total surface area of the storage media. For wafer scale patterned media with low conserved surface area ratio, head liftoff cannot be achieved at designed normal load. However, a 50% reduction of load allows slider head liftoff.
Identifer | oai:union.ndltd.org:GATECH/oai:smartech.gatech.edu:1853/5103 |
Date | 13 July 2004 |
Creators | Horton, Brian David |
Publisher | Georgia Institute of Technology |
Source Sets | Georgia Tech Electronic Thesis and Dissertation Archive |
Language | en_US |
Detected Language | English |
Type | Thesis |
Format | 3421962 bytes, application/pdf |
Page generated in 0.0108 seconds