Two main areas are considered in this manuscript. The first describes the synthesis of group 10 metal complexes incorporating the water-soluble 1,3,5-triaza-7-phosphaadamantane (PTA) ligand and the second deals with the preparation of Cr(salen)X catalysts for the copolymerization of CO2 and epoxides. In the first topic, the synthesis of nickel(II) and palladium(II) salicylaldiminato complexes incorporating PTA has been achieved employing two preparative routes. Upon reacting the original ethylene polymerization catalyst developed by Grubbs and coworkers (Organometallics, 1998, 17, 3149), (salicylaldiminato)Ni(Ph)PPh3, with PTA using a homogeneous methanol/toluene solvent system resulted in the formation of the PTA analogs in good yields. Alternatively, complexes of this type may be synthesized via a direct approach utilizing (TMEDA)M(CH3)2 (M = Ni, Pd), the corresponding salicylaldimine, and PTA. Polymerization reactions were attempted using the nickel-PTA complexes in a biphasic toluene/water mixture in an effort to initiate ethylene polymerization by trapping the dissociated phosphine ligand in the water layer, thereby, eliminating the need for a phosphine scavenger. Unfortunately, because of the strong binding ability of the small, donating phosphine (PTA) as compared to PPh3, dissociation did not occur at a temperature where the complexes are not subjected to decomposition. Additionally, the unexplored PTA derivative, 3,7-diacetyl-1,3,7-triaza-5-phosphabicyclo[3.3.1]nonane (DAPTA), prepared by the literature procedure, was fully characterized by NMR and X-ray analysis. DAPTA is found be similar to its parent (PTA) in coordination mode and binding strength, as supported by its representative group 6 and group 10 complexes
The second main topic involves the copolymerization of CO2 and epoxides (i.e., cyclohexene oxide (CHO)) for the formation of polycarbonate using Cr(salen)X (X = Br, OPh) catalysts with one equivalent of PR3 as the co-catalyst. The use of these catalysts and cocatalysts results in the most active chromium-based catalytic systems to date. The
. hr-1highest activities observed are on the order of 109 mol CHO consumed . mol Cr-1 using PCy3 as the co-catalyst, and is clearly seen in the in situ monitoring of copolymer formation. An advantage of these systems involves the lack of cyclic carbonate production and high CO2 incorporation (>99%) within the polymer.
| Identifer | oai:union.ndltd.org:tamu.edu/oai:repository.tamu.edu:1969.1/359 |
| Date | 30 September 2004 |
| Creators | Ortiz, Cesar Gabriel |
| Contributors | Darensbourg, Donald J. |
| Publisher | Texas A&M University |
| Source Sets | Texas A and M University |
| Language | en_US |
| Detected Language | English |
| Type | Book, Thesis, Electronic Dissertation, text |
| Format | 2262994 bytes, 387663 bytes, electronic, application/pdf, text/plain, born digital |
Page generated in 0.0027 seconds