Global ETD Search

1	Mononuclear and multinuclear salicylaldimine metal complexes as catalysts precursors in the oxidation of phenol and cyclohexene Van Wyk, Juanita Lizélle January 2009 (has links) Philosophiae Doctor - PhD / In this thesis typical homogeneous and dendritic immobilized catalysts derived from salicylaldimines were investigated as catalysts for the oxidation of hydrocarbons using hydrogen peroxide as oxidant under aerobic conditions. This research work thus describes the synthesis of several new N-(aryl)salicylaldimines as well as peripheral functionalised salicylaldimine poly(propyleneimine) dendrimers. The dendritic ligands were obtained by modifying the peripheral groups of Generation 1 and Generation 2 poly(propyleneimine) dendrimer, (DAB-(NH2)n) which are commercially available. Both types of ligands were utilized to synthesize Cu(II) and Co(II) complexes using appropriate acetate salts. The ligands systems and metal complexes prepared were fully characterized using a range of physical techniques. The Cu(II) and Co(II) complexes were evaluated as catalysts for the oxidation of phenol and cyclohexene using hydrogen peroxide as oxidant under an oxygen atmosphere. The catalytic oxidation of phenol to the dihydroxybenzenes, catechol (CT) and hydroquinone (HQ), was investigated in aqueous media at various pH values. All the complexes investigated were active for the hydroxylation process producing CT as major product. The pH of the reaction medium was found to have much more of an influence on the activity and product selectivity of the Co(II) complexes as compared to the case for the Cu(II) complexes. All the catalysts investigated were also found to exhibit good activity for the oxidation of cyclohexene producing predominantly the allylic oxidation products 2-cyclohexene-1-one and 2-cyclohexene-1-ol. However the formation of the epoxide, cyclohexene oxide was also observed as minor product or in trace quantities. It was found that the cobalt catalysts produced 2-cyclohexene-1-one as major product, however higher levels of 2-cyclohexene- 1-ol was produced by all catalysts in catalytic runs where the oxidant to substrate ratio was reduced and when the metal loading was increased. In the case of the copper catalysts 2- cyclohexene-1-ol was produce in slightly higher levels than 2-cyclohexene-1-one. Catalysts precursors Oxidation of phenol
2	Development of Calcium and Palladium Catalysts for the Formation of Carbon-Carbon and Carbon-Heteroatom Bonds Kunchithapatham, Kamala 25 June 2012 (has links) No description available. Chemistry catalysis calcium salicylaldimine hydroamination cross-coupling thioesters oxazoles C-H activation terminal olefins vinylsilanes
3	Synthesis of 1,3,5-triaza-7-phosphaadamantane (PTA) and 3,7-diacetyl-1,3,7-triaza-5-phosphabicyclo[3.3.1]nonane (DAPTA) complexes and the development of chromium salen catalysts for the copolymerization of CO2 and epoxides Ortiz, Cesar Gabriel 30 September 2004 (has links) Two main areas are considered in this manuscript. The first describes the synthesis of group 10 metal complexes incorporating the water-soluble 1,3,5-triaza-7-phosphaadamantane (PTA) ligand and the second deals with the preparation of Cr(salen)X catalysts for the copolymerization of CO2 and epoxides. In the first topic, the synthesis of nickel(II) and palladium(II) salicylaldiminato complexes incorporating PTA has been achieved employing two preparative routes. Upon reacting the original ethylene polymerization catalyst developed by Grubbs and coworkers (Organometallics, 1998, 17, 3149), (salicylaldiminato)Ni(Ph)PPh3, with PTA using a homogeneous methanol/toluene solvent system resulted in the formation of the PTA analogs in good yields. Alternatively, complexes of this type may be synthesized via a direct approach utilizing (TMEDA)M(CH3)2 (M = Ni, Pd), the corresponding salicylaldimine, and PTA. Polymerization reactions were attempted using the nickel-PTA complexes in a biphasic toluene/water mixture in an effort to initiate ethylene polymerization by trapping the dissociated phosphine ligand in the water layer, thereby, eliminating the need for a phosphine scavenger. Unfortunately, because of the strong binding ability of the small, donating phosphine (PTA) as compared to PPh3, dissociation did not occur at a temperature where the complexes are not subjected to decomposition. Additionally, the unexplored PTA derivative, 3,7-diacetyl-1,3,7-triaza-5-phosphabicyclo[3.3.1]nonane (DAPTA), prepared by the literature procedure, was fully characterized by NMR and X-ray analysis. DAPTA is found be similar to its parent (PTA) in coordination mode and binding strength, as supported by its representative group 6 and group 10 complexes The second main topic involves the copolymerization of CO2 and epoxides (i.e., cyclohexene oxide (CHO)) for the formation of polycarbonate using Cr(salen)X (X = Br, OPh) catalysts with one equivalent of PR3 as the co-catalyst. The use of these catalysts and cocatalysts results in the most active chromium-based catalytic systems to date. The . hr-1highest activities observed are on the order of 109 mol CHO consumed . mol Cr-1 using PCy3 as the co-catalyst, and is clearly seen in the in situ monitoring of copolymer formation. An advantage of these systems involves the lack of cyclic carbonate production and high CO2 incorporation (>99%) within the polymer. CO2 Polycarbonate Chromium Water-Soluble Phosphines PTA DAPTA Epoxide Aqueous Organometallic Chemistry Salen Daco Dach Ethylene Polymerization Salicylaldimine
4	Investigations into cyclopropanation and ethylene polymerization via salicylaldiminato copper (II) complexes Boyd, Ramon Cornell 23 January 2007 Two distinct overall research objectives are in this Masters thesis. Very little relates the two chapters apart from the ligands. The first chapter addresses diastereoselective homogeneous copper catalyzed cyclopropanation reactions. Cyclopropanation of styrene and ethyl diazoacetate (EDA) is a standard test reaction for homogeneous catalysts. Sterically bulky salicylaldimine (SAL) ligands should select for the ethyl trans-2-phenylcyclopropanecarboxylate diastereomer. Steric bulk poorly influences trans:cis ratios. Salicylaldiminine ligands do not posses the correct symmetry to affect diastereoselectivity. The SAL ligand belongs to the Cs point group in the solid state. Other ligand motifs are more effective at altering the trans:cis ratios. The second chapter addresses the general route toward successful copper(II) ethylene polymerization catalysts. Catalytic activity of the copper(II) complexes is very low. Polymer chain growth from a copper catalyst is very unlikely. Copper-carbon bonds decompose by homolytic cleavage or C-H activation. Copper-alkyls and aryls readily decompose into brown colored oils and salts with different colors. Ligand transfer to trimethylaluminum (TMA) appears to explain low yield ethylene polymerization. bulky migratory insertion mechanism coordination/insertion methodology d-block metal late transition metal phenolic ring coordination number ketimine precatalysts ketimine nitrogen bis(salicylaldiminato)copper(II) ratio cyclopropane steric bulk salicylaldiminato TMA salt trimethylaluminum aryl oil alkyl copper-aryls copper-alkyls C-H activation homolytic homolytic cleavage copper(II) polymerization ethylene cis trans symmetry diastereomer salicylaldimine SAL EDA ethyl diazoacetate styrene cyclopropanation copper diastereoselective steric protection stable CH(SiMe3)2 intermediate catalytic activity associated TMA free TMA vacant coordination site hydrolysis Lewis acid halogen anionic anionic ligand donor ligand monodentate anionic ligand aluminum(III) monodentate polymer chain polymer chain aluminum-carbon bond bulky SAL ligand open coordination site first row transition metal PE paramagnetic high molecular weight polyethylene alkylate methylaluminoxane MAO anionic ligands arylate aluminum carbon aluminum carbon bond beta-hydrogen elimination beta hydrogen elimination Aufbau reaction Aufbau neutral dialkyl aluminum aluminum-alkyl aluminum alkyl copper(0)
5	Investigations into cyclopropanation and ethylene polymerization via salicylaldiminato copper (II) complexes Boyd, Ramon Cornell 23 January 2007 (has links) Two distinct overall research objectives are in this Masters thesis. Very little relates the two chapters apart from the ligands. The first chapter addresses diastereoselective homogeneous copper catalyzed cyclopropanation reactions. Cyclopropanation of styrene and ethyl diazoacetate (EDA) is a standard test reaction for homogeneous catalysts. Sterically bulky salicylaldimine (SAL) ligands should select for the ethyl trans-2-phenylcyclopropanecarboxylate diastereomer. Steric bulk poorly influences trans:cis ratios. Salicylaldiminine ligands do not posses the correct symmetry to affect diastereoselectivity. The SAL ligand belongs to the Cs point group in the solid state. Other ligand motifs are more effective at altering the trans:cis ratios. The second chapter addresses the general route toward successful copper(II) ethylene polymerization catalysts. Catalytic activity of the copper(II) complexes is very low. Polymer chain growth from a copper catalyst is very unlikely. Copper-carbon bonds decompose by homolytic cleavage or C-H activation. Copper-alkyls and aryls readily decompose into brown colored oils and salts with different colors. Ligand transfer to trimethylaluminum (TMA) appears to explain low yield ethylene polymerization. bulky migratory insertion mechanism coordination/insertion methodology d-block metal late transition metal phenolic ring coordination number ketimine precatalysts ketimine nitrogen bis(salicylaldiminato)copper(II) ratio cyclopropane steric bulk salicylaldiminato TMA salt trimethylaluminum aryl oil alkyl copper-aryls copper-alkyls C-H activation homolytic homolytic cleavage copper(II) polymerization ethylene cis trans symmetry diastereomer salicylaldimine SAL EDA ethyl diazoacetate styrene cyclopropanation copper diastereoselective steric protection stable CH(SiMe3)2 intermediate catalytic activity associated TMA free TMA vacant coordination site hydrolysis Lewis acid halogen anionic anionic ligand donor ligand monodentate anionic ligand aluminum(III) monodentate polymer chain polymer chain aluminum-carbon bond bulky SAL ligand open coordination site first row transition metal PE paramagnetic high molecular weight polyethylene alkylate methylaluminoxane MAO anionic ligands arylate aluminum carbon aluminum carbon bond beta-hydrogen elimination beta hydrogen elimination Aufbau reaction Aufbau neutral dialkyl aluminum aluminum-alkyl aluminum alkyl copper(0)

1

Page generated in 0.0592 seconds