M.Sc. / The contamination of water by toxic compounds is one of the most serious environmental problems today. These toxic compounds mostly originate from industrial effluents, agriculture runoff, natural sources (e.g. heavy metals in water from rocks and soil erosion) and human waste. The contamination, which is both “organic” and “inorganic” has an impact on the environment and human health. The demand for water and the pressure to re-use this valuable resource has increased the need for improved techniques and materials to remove pollutants from water. The Nanomaterials Science research group at the University of Johannesburg has focused on developing synthetic polymers that can be employed in water treatment and pollutant monitoring. Recently, cyclodextrins (CD) and carbon nanotubes (CNTs) have been included in polymers for this application. For example, CD-co-hexamethylene-/toluene-diisocyanate polyurethanes and CNT-modified equivalents have been developed and have been successfully applied in removing organic contaminants from water to very low levels.1 Calixarenes are synthetic analogues of cyclodextrins that can be exploited via chemical modification to express a range of properties. In the present study, calixarenes, thiacalixarenes and carbon nanotube-based polymeric materials incorporating these molecules have been synthesised, characterised and tested for removing both organic pollutants (such as p-nitrophenol) and inorganic pollutants (Cd2+, Pb2+) from water. Lead(II) and Cadmium(II) are a threat in South Africa because of their toxicity, and while p-nitrophenol is much less of a problem it represents a useful model organic pollutant. The absorption capacity of the polymers towards heavy metals and organic contaminants was tested by mixing the polymer with synthetic water containing known concentration of the contaminants at about 10 mg/L. Atomic absorption spectrometry (AAS) and ultraviolet-visible spectrometry (UV-vis) were used to determine the levels of heavy metals and organic contaminants, respectively. The target pollutants (Cd2+, 1 see KL Salipira MTech dissertation, University of Johannesburg 2008 Pb2+ and p-nitrophenol) were all successfully removed from water by the various polymers, however the degree of removal and loading capacities of the polymers differed. This information gives some insight into what functional components are needed for making successful adsorbents. It was observed, for example, that ptert- butylcalix[8]arene/hexamethylene diisocyanate (C8A/HMDI) had a higher adsorption capacity towards p-nitrophenol and Pb2+ than towards Cd2+, and also a higher capacity than the corresponding calix[4]arene polymers with smaller calixarene cavities.
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:uj/uj:2231 |
| Date | 02 May 2012 |
| Creators | Makayonke, Nozuko Thelma |
| Source Sets | South African National ETD Portal |
| Detected Language | English |
| Type | Thesis |
Page generated in 0.0021 seconds