Return to search

Uppföljning av skuthantering i Aitik / Boulder Handling in Aitik

Detta examensarbete handlar om att följa upp skuthantering i Aitik och dess ekonomiska påverkan, Aitik är en dagbrottsgruva som ligger i Gällivares kommun. Skut är ett bergblock som är större än 1 m3 och är ett återkommande problem då de orsakar störningar i produktionsflödet. Totalt genomfördes tre fältstudier som inriktades på lastning, skutknackning och kross. Ett utav målen var att undersöka om det är lönsamt att låta Aitiks entreprenör knacka skut, detta genom att jämföra kostnaden som entreprenören fakturerar mot att hantera skuten som gråberg vilket medför en deponiförlust av kopparvärdet. Hantering av skut kan ske på två olika sätt, hantering vid upplag och hantering vid salva. Dessa två metoder jämförs för att se vilken som är mest lönsam. Ett annat mål var att undersökahur stor inverkan skut har i krossen då de orsakar stopp, och därefter jämföra dessa stopporsaker mot krossoperatörens inrapporterade stopporsak, vilket denne gör i Aitiks Sogetisystem. Studien åskådliggör att det inte är lönsamt att låta entreprenören hantera skut vid kopparhalten 0,06 %. För kopparhalter kring 0,1 % bör vidare undersökningar genomföras om det är lönsamt eller ej. Vid 0,2 % och över är det lönsamt med skuthantering från entreprenören. Skuthantering vid upplag är den mest lönsamma metoden så länge dieselpriset understiger 10 kr per liter. Skut har en stor negativ inverkan på produktionseffektiviteten i krossen. Totalt orsakades 86 minuter stopp i krossen på grund av skut under två skift. Detta motsvarar ca 400 000 kr i produktionsförlust, vid produktionseffektiviteten 4041 ton per timme vilket var den verkliga effektiviteten hos krossen under det ena skiftet. Olikheter påträffades vid jämförelse mellan dokumenterade stopporsaker och operatörernas stopporsaker i Sogeti. Vid uppföljande studier bör hänsyn tas till kostnader för truckslitage i beräkningar av skuthantering, då detta kan påverka resultatet. Fler fältstudier bör utföras för att få ett mer tillförlitlig resultat. / This thesis is about following up the handing of boulders and its economic impact. Aitik is an open-pit mine located near Gällivare in Norrbotten. According to Aitik, a boulder is a rough stone that is larger than 1 m3, and they are a recurrent problem because boulders cause a disturbance in the production flow. A total of three field studies were done which focused on loading, boulder breaking and crushing. The goal was to investigate if it was going to be profitable to let Aitik´s entrepreneur handle boulders using a hydraulic breaker, thus comparing the invoice from Aitik´s entrepreneur compared to handling the boulders as waste rock, which entails a landfill loss of the copper value. The handling of boulders can occur in two different ways, handling at stockpile or handling at burst. These two methods are compared with each other to see which one is the most profitable. Beyond this it was also examined on how much of an impact boulders have in the crushing section when they cause a stop, and thereafter compare these stops against the reported stoppage from the operators which is done in Aitiks Sogetisystem. The study illustrates that it is not profitable to let Aitik´s entrepreneur handle boulders at the copper content 0,06 %. Copper concentrations around 0,1 % should be further analyzed whether it is profitable or not. At 0,2 % and above it is profitable to let Aitik´s entrepreneur handle the boulders. Handling boulders at stockpile is the most profitable method as long as the fuel cost is below 10 SEK per liters. Boulders have a large negative impact on the production efficiency in the crushing section. In two shifts there were a total of 86 minutes stop in the crusher caused by boulders, this corresponds to about 400 000 SEK in production loss at a production efficiency of 4041 tons per hour, which was the actual efficiency during one of the shifts. Differences occurred among the documented stop causes and the stop causes made by the operators in Sogeti. For further studies, a regard should be made occurring costs of truck wear due to boulder handling as this may affect the results. Also perform more field studies in order to get a more reliable result.

Identiferoai:union.ndltd.org:UPSALLA1/oai:DiVA.org:ltu-61049
Date January 2017
CreatorsJönsson, Simon, Olsson, Albert
PublisherLuleå tekniska universitet, Institutionen för samhällsbyggnad och naturresurser, Luleå tekniska universitet, Institutionen för samhällsbyggnad och naturresurser
Source SetsDiVA Archive at Upsalla University
LanguageSwedish
Detected LanguageSwedish
TypeStudent thesis, info:eu-repo/semantics/bachelorThesis, text
Formatapplication/pdf
Rightsinfo:eu-repo/semantics/openAccess

Page generated in 0.0025 seconds