Abstract
This thesis studies controlling factors that govern transverse hydrogen cracking in high-strength multipass weld metal (WM). The experiments were concerned with heavy-restraint Y- and U-Groove multipass cracking tests of shielded-metal arc (SMAW) and submerged-arc (SAW) weld metals. Results of tensile tests, hardness surveys, weld residual stress measurements and microstructural investigations are discussed. The analytical phase comprised numerical calculations for analysing the interactions between crack-controlling factors. The objectives were: (i) the assessment of WM hydrogen cracking risk by defining the Crack-No Crack boundary conditions in terms of 'safe line' description giving the desired lower-bound estimates, and (ii) to derive predictive equations capable of giving reliable estimates of the required preheat/interpass temperature T0/Ti for the avoidance of cracking.
Hydrogen cracking occurred predominantly in high strength weld metals of Rp0.2 ≈ 580-900 MPa. At intermediate strengths of Rp0.2 ≈ 500-550 MPa, cracking took place in the cases where the holding time from welding to NDT inspection was prolonged to 7 days. Low strength WMs of Rp0.2 ≤ 480 MPa did not exhibit cracking under any conditions examined. Cracking occurrence was, above all, governed by WM tensile strength, weld diffusible hydrogen and weld residual stresses amounting to the yield strength. The appearance of cracking vanished when transferring from 40 to 6 mm thick welds. The implications of the holding time were more significant than anticipated previously. A period of 16 hrs in accordance with SFS-EN 1011 appeared much too short for thick multipass welds. Interpass time and heat input showed no measurable effect on cracking sensitivity, hence being of secondary importance. Equations were derived to assess the weld critical hydrogen content Hcr corresponding to the Crack-No Crack conditions as a function of either weld metal Pcm, yield strength Rp0.2 or weld metal maximum hardness HV5(max). For the calculation of safe T0/Ti estimates, a formula incorporating: (i) WM strength as a linear function of either weld carbon equivalent CET or weld HV5(max), (ii) weld build-up thickness aw in the form of tanh expression and (iii) weld diffusible hydrogen HD in terms of a combined [ln / power law] expression was found descriptive.
| Identifer | oai:union.ndltd.org:oulo.fi/oai:oulu.fi:isbn951-42-7181-5 |
| Date | 15 November 2003 |
| Creators | Nevasmaa, P. (Pekka) |
| Publisher | University of Oulu |
| Source Sets | University of Oulu |
| Language | English |
| Detected Language | English |
| Type | info:eu-repo/semantics/doctoralThesis, info:eu-repo/semantics/publishedVersion |
| Format | application/pdf |
| Rights | info:eu-repo/semantics/openAccess, © University of Oulu, 2003 |
| Relation | info:eu-repo/semantics/altIdentifier/pissn/0355-3213, info:eu-repo/semantics/altIdentifier/eissn/1796-2226 |
Page generated in 0.0058 seconds