Return to search

[en] EVALUATION OF THE PERFORMANCE OF THE METHOD OF TPH DETERMINATION (TOTAL HYDROCARBON PETROLEUM) IN SAND FOR DETECTION IN INFRA RED / [pt] AVALIAÇÃO DO DESEMPENHO DO MÉTODO DE DETERMINAÇÃO DE TPH (TOTAL PETROLEUM HYDROCARBON) EM AREIA POR DETECÇÃO NO INFRAVERMELHO

[pt] No presente trabalho realizou-se a otimização da
metodologia de análise de TPH (Total Petroleum
Hydrocarbons) em amostras de areia contaminadas
com petróleo, validando a técnica de detecção na região do
infravermelho com o equipamento da Infracal TOG/TPH.
Os ensaios foram realizados utilizando Óleo Marine Fuel
380, com densidade igual 0,987 g cm-3 e viscosidade de 5313
cP a 20 Graus Celsius. Este óleo foi fornecido pelo Centro de Pesquisa
da Petrobrás (CENPES/PETROBRÁS/RJ), sendo o mesmo óleo
derramado no acidente ocorrido em janeiro de 2000 na
Baia de Guanabara, RJ, quando 1.300 m3 vazaram do duto que
interliga a REDUC (Refinaria Duque de Caxias, RJ) ao
terminal da Ilha d`Água/RJ, atingindo praias.
A metodologia otimizada foi aplicada na determinação de TPH
em amostras de areia contaminada com petróleo do referido
acidente, sendo que em 110 amostras analisadas, foram
obtidos resultados de TPH na faixa de 10,0 a 155,0 g Kg-1.
Os resultados da validação indicaram que o desempenho da
metodologia foi muito favorável à aplicação que se destina.
Entre os parâmetros metrológicos obtidos neste trabalho, o
limite de detecção do método foi de 9,44 mg l-1,
consideravelmente inferior à faixa de concentração
normalmente obtida para tais amostras. / [en] This dissertation deals with an optimization of TPH (Total
Petroleum Hydrocarbon) analysis methodology for samples of
contaminated sands, validating the infrared detection
technique through the use of Infracal TOG/TPH
equipment. Tests were validated using Marine Fuel 380 oil,
density 0.987 g cm-3 and viscosity 5313 cP at 20 Celsius Degrees. This
oil sample was kindly supplied by Petrobras Research Centre
(CENPES), and is the same oil that leaked from a pipeline in
REDUC Refinery on January 2000, contaminating several
beaches in Guanabara Bay, including Anil and Mauá.
The optimized methodology was applied on 110 sand samples
contaminated with the aforementioned oil, and TPH were
determined within the range of 10.0 to 155.0 g kg-1.
The validation results suggested that the methodology
performance was adequate for this application. Amongst the
metrological parameters obtained from this work, the
detection limit, 9.44 mg l-1, was a plus; since it was far
below to the concentration range obtained from this samples.

Identiferoai:union.ndltd.org:puc-rio.br/oai:MAXWELL.puc-rio.br:4059
Date31 October 2003
CreatorsALEXANDRE RODRIGUES DO NASCIMENTO
ContributorsROBERTA LOURENCO ZIOLLI, ROBERTA LOURENCO ZIOLLI, JOSE TAVARES ARARUNA JUNIOR
PublisherMAXWELL
Source SetsPUC Rio
LanguagePortuguese
Detected LanguagePortuguese
TypeTEXTO

Page generated in 0.0019 seconds