Back to search

University of Birmingham

Microstructure characterisation and creep modelling of HP40 alloys

Abstract

dc:description.abstract

The efficiency of steam reforming depends strongly on the creep resistance of the material used for the reformer tubes. The currently most widely used reformer tube material is HP40 (25 Cr, 35Ni, 40 Fe and 0.4C) austenitic stainless steel. A further improvement in the creep resistance of HP40 is needed for efficiency improvement and for a cost reduction in steam reforming. In order to develop a next generation creep resistant alloy, three HP40-based alloys, namely Alloy A, B and C, with different chemical compositions and/or solidification rate, were studied. Previous tests at 1000 oC and 40 MPa have shown that the creep properties of Alloy C are slightly better than those of Alloy B, both being significantly better than Alloy A. The microstructures of three alloys, under as-cast, crept and heat treated conditions, have been analysed so as to understand their relative creep performance. The small intragranular M23C6 may have contributed significantly to the smaller creep rate, and thus a longer creep life for Alloy B and Alloy C as compared with Alloy A. A microstructure-based climb-glide bypass creep model was described to predict the creep behaviour of HP40. Suggestion on the next generation HP40 alloy has been made.

Degree

thesis:*
Name dc:type.qualificationname
d_ph
Level dc:type.qualificationlevel
d_ph
Grantor dc:publisher.institution
University of Birmingham
Year dc:date.issued
2017

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Wang, Minshi

Subjects

dc:subject × 2

Rights

Language dc:language.dcterms_iso639_2
eng

Chain of custody

source
Harvested from
University of Birmingham
Base URL
etheses.bham.ac.uk/cgi/oai2
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Wang, Minshi. Microstructure characterisation and creep modelling of HP40 alloys. d_ph thesis, University of Birmingham, 2017.