Back to search

Boston University

Adherence of polyetheretherketone (PEEK) to different veneering materials and evaluation of the mechanical properties

Abstract

dc:description.abstract

OBJECTIVES: To test and compare the effects of thermocycling, different bilayer material combinations, and different core/veneer material combinations on shear bond strength, flexural strength, and failure load of different dental restorative materials. METHODS: In this in-vitro study, 369 specimens were prepared from four materials; PEEK (Juvora), Vita Enamic, MarkII, and InCoris (Sirona). 144 specimens were divided into 12 groups and sectioned into plates (frameworks) and rods (veneers) for the shear bond strength test. The final dimension of each plate was about 18mm in length, 2mm thick, and 12mm in width. While the rods were core drilled to have a final diameter of 3.48mm. All plates and rods underwent surface treatment before bonding with adhesive resin (3M RelyX Ultimate), half of the specimens were thermal aged with 5,000 cycles before a shear bond strength test was performed on all specimens. 225 specimens were sectioned into bars for bilayer flexural strength test and load to failure analysis. The final dimension of the bars was 18mm in length, 2mm thickness, and 4mm width, bars were assigned into groups of tension materials and compression materials to be bonded together as a bilayer bar structure. Half of the bilayer bars underwent thermal aging. All bilayer and monolayer bars were tested for flexural strength, load to failures values were also analyzed as well as the mode of failures. RESULTS: The results of this study show that Enamic groups (EN/MKII) showed the highest shear bond strength (SBS) followed by Zirconia groups (Zr/En, Zr/MKII). PEEK groups show the lowest SBS values among the tested groups. Thermal aging did not affect SBS specimens except for Zr/En group where it decreases the SBS values. There was a significant difference in bilayer flexural strength and failure loads of Zirconia groups (Zr/En, Zr/MKII) were higher than other groups. PEEK groups (PEEK/EN, PEEK/MKII, PEEK/Zr) showed the lowest FS bilayer and load to failure values. CONCLUSION: SBS to PEEK was lower as compared to the other tested groups. Materials in tension and the adhesive interface layer significantly impact the bilayer flexural strength and failure load values.

Degree

thesis:*
Name thesis:degree_name
Doctor of Science in Dentistry
Level thesis:degree_level
doctoral
Discipline thesis:degree_discipline
Prosthodontics
Grantor
Boston University
Year dc:date.issued
2020

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Hafiz, Walid Khalid
Advisors dc:contributor.advisor
  • Giordano II, Russell
  • Fan, Yuwei
ORCID dc:identifier.orcid

Subjects

dc:subject × 1

Rights

Language dc:language.iso
en_US

Identifiers

dc:identifier.*
Handle dc:identifier.uri
https://hdl.handle.net/2144/42219

Chain of custody

source
Harvested from
Boston University
Base URL
open.bu.edu/oai/request
Last updated
2026-11-18
Source record
OAI-PMH GetRecord
related terms
citation

Hafiz, Walid Khalid. Adherence of polyetheretherketone (PEEK) to different veneering materials and evaluation of the mechanical properties. doctoral thesis, Boston University, 2020. https://hdl.handle.net/2144/42219