Back to search

Clemson University

Dynamic Topology Optimization and Experimental Validation of Reinforcement for PCB Robotics

Abstract

dc:description.abstract

Ongoing research between Clemson University and the NASA Jet Propulsion Laboratory (JPL) has been conducted to characterize and assess rigid-flex printed circuit board (PCB) robotics subjected to dynamic loads. A lightweight, PCB lunar rover, PUFFER (Pop-Up Flat Folding Explorer Robot), was designed by NASA JPL for Mars missions, but its deployment for lunar missions has been investigated as well. Its current architecture, however, is insufficient for navigating and surviving the lunar environment, and reinforcement has been recommended as a solution to protect larger panels. This research work presents a dynamic topology optimization process for PCB panel reinforcement. A thorough literature review was completed to investigate prior research efforts regarding existing optimization methodologies and prevalent PCB failure mechanisms. There are a notable lack of adequate reinforcing solutions for PCB and a lack of established dynamic topology optimization methodology for PCB that leverages commercial software. To address this gap in research, a dynamic topology optimization workflow was proposed for rigid-flex PCB robotics. Specifically, this workflow focused on optimizing reinforcement for PUFFER. The objectives of this research were to design a PCB specimen for a single-panel reinforcement optimization routine and experimental testing, preliminarily demonstrate the optimization routine for various output metrics using commercial analysis software (specifically, Abaqus), and correlate the finite element model (FEM) with modal testing results for model validation. These research objectives were fulfilled through the design of the PCB specimen and a custom vibration shaker head expander for experimental testing, the selection of an appropriate power spectral density (PSD) test specification to simulate launch loads for interplanetary missions, the preliminary demonstration of a single-panel reinforcement optimization procedure for the output metrics of maximum strain energy and maximum absolute principal stress in the PCB, and the modification and correlation of the FEM to modal testing results. The dynamic topology optimization procedure demonstrated that the output metric of maximum absolute principal stress was slightly more optimal for the designed PCB specimen. Model validation efforts were successful in correlating the FEM to experimental testing results.

Degree

thesis:*
Name thesis:degree_name
Master of Science (MS)
Level thesis:degree_level
Thesis
Discipline thesis:degree_discipline
Civil Engineering

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Semler, Ryan G.
Contributors dc:contributor
  • Laura Redmond
  • Weichiang Pang
  • M.Z. Naser

Subjects

dc:subject × 7

Identifiers

dc:identifier.*
Repository record dc:identifier
https://open.clemson.edu/all_theses/4661

Chain of custody

source
Harvested from
Clemson University
Base URL
open.clemson.edu/do/oai/
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Semler, Ryan G.. Dynamic Topology Optimization and Experimental Validation of Reinforcement for PCB Robotics. Thesis thesis, https://open.clemson.edu/all_theses/4661