Back to search

Georgia Institute of Technology

Fabrication and analysis of injection molded plastic microneedle arrays

Abstract

dc:description.abstract

This thesis describes the fabrication of plastic microneedle devices, their fabrication by injection molding, and analysis of the penetration mechanics. Injection molding is an economical mass-production technique that may encourage widespread adoption of microneedles for drug delivery. Four polymers were injection molded into hexagonal and square patterns of between 91 and 100 needles per array. The patterns and geometries were chosen to study the effect of needle spacing and array design on penetration force. Two needle spacings of approximately 1 mm and 1.5 mm were employed for both patterns. Molded parts showed tip radii below 15 microns, heights of 600 to 750 microns, and an included angle of approximately 30 degrees. An economic analysis performed of the injection molded polymer devices showed that they can be manufactured for approximately $0.10 - $0.179 per part, which should be low enough to gain market acceptance. The added benefits of low pain perception, improved drug delivery for certain treatments, and the possibly of being recyclable make injection molded micro-needle devices a desirable alternative to silicon or metal microneedles. Penetration tests were performed with plastic micro-needle arrays and arrays of steel needles of the same spacings and patterns. Silicone rubber with mechanical properties similar to human skin was used as a skin simulant. The results showed that the micro-needles penetrated skin to depths between 120 and 185 microns depending on pattern, spacing, tip radius and needle length. This depth is sufficient to deliver drug therapies, but not so far that they stimulate the nerve endings present beyond 130 microns inside the dermis layer in human skin. An analytical model was developed to estimate the effects of various microneedle and skin characteristics on penetration force. The model was based on literature sources and derived from test results. The model accounted for coefficient of friction, tip radius, tip angle, and needle spacing, as well as the skin mimic's mechanical properties such as elastic modulus, mode I fracture toughness, and puncture fracture toughness. A Monte Carlo simulation technique was used to correct for errors in needle length and testing angle. Comparison of the experiments to the model showed good agreement.

Degree

thesis:*
Department dc:contributor.department
Mechanical Engineering
Grantor dc:publisher
Georgia Institute of Technology
Year dc:date.issued
2011

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Hamilton, Jordan David
Advisor dc:contributor.advisor
  • Colton, Jonathan S.
Committee members dc:contributor.committeemember
  • Ku, David
  • Prausnitz, Mark

Subjects

dc:subject × 7

Identifiers

dc:identifier.*
Handle dc:identifier.uri
http://hdl.handle.net/1853/39481

Chain of custody

source
Harvested from
Georgia Tech
Base URL
repository.gatech.edu/server/oai/request
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Hamilton, Jordan David. Fabrication and analysis of injection molded plastic microneedle arrays. Georgia Institute of Technology, 2011. http://hdl.handle.net/1853/39481