Georgia Institute of Technology
Modeling, design and demonstration of through-package-vias in panel-based polycrystalline silicon interposers for high performance, high reliability and low cost
Abstract
dc:description.abstractSilicon interposers with TSVs (through-silicon-vias) have been developed in single-crystalline silicon wafer to achieve the high I/O (Input/Output) density. However, single-crystalline silicon interposers suffer a few problems such as cost, electrical performance and reliability. To overcome these shortcomings, an entirely different approach using polycrystalline silicon interposers with thick polymer liners are proposed by Georgia Tech Packaging Research Center, aiming to achieve lower cost silicon interposers with high performance and reliability. The objective of this research is to explore and demonstrate thin polycrystalline silicon as a suitable interposer material to achieve high performance and high reliability TPVs (through-package-vias) in polycrystalline silicon materials with lower cost. Three fundamental challenges were defined, including: 1) low resistivity of the polycrystalline silicon, resulting in high electrical loss; 2) reliability problems resulting from CTE (coefficient of thermal expansion) mismatch between silicon and Cu, and 3) handling and processing of thin silicon panels. A three-dimensional EM (electromagnetic) model was developed to simulate insertion loss and crosstalk of TPVs and compared with TSVs. It has been shown thick polymer liner is effective in addressing the fundamental challenge of low resistivity for the polycrystalline silicon material, leading to better electrical performance of TPVs than TSVs. Parametric studies indicate that thicker sidewall liners result in better electrical performance. A two-dimensional axisymmetric model was established to simulate the first principal stresses in silicon and shear stresses in TPV under thermal cycling. TPVs with thick polymer liners present both smaller principal stresses and shear stresses than TSVs due to the low modulus of polymer. Parametric studies suggest that sidewall liners act as stress buffers and thicker liners result in better mechanical performance. Design guidelines based on simulation results were used in TPV demonstration and test vehicle fabrication. Fracture strength of polycrystalline silicon panel has been fundamentally studied with four-point bending tool and Weibull plot. Surface polymer liners on both sides were introduced to improve the handling of thin silicon panels. Quantitative study showed higher characteristic fracture strength for the panel with surface liners than raw silicon panel. Low cost and double-side processes have been developed for TPV fabrication including UV (ultraviolet) lasers for TPV formation, double laser method for liner fabrication and electroless Cu for seed formation. Key steps and mechanisms for aforementioned processes were summarized and discussed. Polycrystalline silicon interposers with TPVs and up to four metal RDLs (re-distribution layers) were designed, fabricated and characterized. Measurement results showed low insertion loss for both TPVs and CPW (co-planar waveguide) transmission lines. Good model to hardware correlation was also observed. Reliability test vehicles of polycrystalline silicon interposers were also designed and fabricated for thermal cycling test. TPVs survived 4000 cycles without significant resistance changes. SEM imaging on the cross-section of the samples confirmed no Cu or silicon cracking. Magnified images around corner also suggested good adhesion at Cu/liner and silicon/liner interfaces.
Degree
thesis:*- Level thesis:degree_level
- Doctoral
- Department dc:contributor.department
- Electrical and Computer Engineering
- Grantor dc:publisher
- Georgia Institute of Technology
- Year dc:date.issued
- 2015
Author and committee
dc:creator, dc:contributor.*- Author dc:creator
-
- Chen, Qiao
- Advisor dc:contributor.advisor
-
- Tummala, Rao R.
- Committee members dc:contributor.committeemember
-
- Rohatgi, Ajeet
- Lim, Sung Kyu
- Sitaraman, Suresh
- Sundaram, Venky
Subjects
dc:subject × 3Rights
- Language dc:language.iso
- en_US
Identifiers
dc:identifier.*- Handle dc:identifier.uri
- http://hdl.handle.net/1853/53568