University of Glasgow
Rapid prototyping of injection moulded microfluidics with in-built sensing
Abstract
dc:description.abstractMicrofluidics have been utilised over the past few decades to realise a wide range of academic research. These fluidic devices carry several advantages over classical analytical techniques such as lower reagent consumption, more rapid reactions, and increased sensitivity. However, while many of the currently used fabrication techniques allow for the rapid prototyping of microfluidic structures, these methods, and the design rules associated with them, do not translate well into mass-producible devices. For example, devices can be manufactured rapidly using soft lithography methods however, this requires access to specialist clean-room facilities and the through-put is limited to only a handful of devices per day. To address this, the work in this thesis focuses on developing a manufacturing platform that allows for the rapid prototyping of microfluidic devices using injection moulding. This process not only allows for the fabrication of hundreds of devices per day, but also allows for the use of materials such as polystyrene which have material properties that are better suited for applications such as cell culture. To achieve this, 3D printed inlays were evaluated for use in an industrial injection moulding machine and it was found that channels as small as 100 x 200 μm could be reliably manufactured. To complement this manufacturing platform, an oxygen sensor was also demonstrated that could be rapidly incorporated into the microfluidic devices without the requirement of clean-room facilities. This sensor could detect oxygen with high enough spatial and temporal resolution for most cell culture applications. Alongside this, steps towards making a device for measuring cell barrier integrity were also made. This work showed how functional elements such as electrodes and membranes could be rapidly incorporated into the injection moulded devices. However, a full demonstration of working trans-epithelial/endothelial-resistance measurements was not achieved. Overall this work demonstrates a novel manufacturing platform that should enable a more seamless transition from prototype, to mass-produced microfluidic devices in the future.
Degree
thesis:*- Level dc:type.qualificationlevel
- PhD
- Grantor dc:publisher.institution
- University of Glasgow
- Year dc:date.issued
- 2024
Author and committee
dc:creator, dc:contributor.*- Author dc:creator
-
- Convery, Neil
Subjects
dc:subject × 2Rights
- Language dc:language
- en
Identifiers
dc:identifier.*- DOI dc:identifier.doi
- https://doi.org/10.5525/gla.thesis.84189