Back to search

University of Glasgow

Development of low-resistance ohmic contacts in GaN heterostructures using silicon Ion implantation

Abstract

dc:description.abstract

The formation of low-resistance Ohmic contacts remains an important consideration in the development of III-nitride electronic devices. This thesis investigates approaches for reducing Ohmic contact resistance (Rc) in AlGaN/GaN and AlN/GaN heterostructures, with particular emphasis on patterned recessed Ohmic contacts, silicon (Si) ion implantation, and the relative positioning of the recess and Ohmic metallisation. The first experimental study investigated the influence of recess patterning on Ohmic contact resistance. Localised recess patterns with dimensions of 4 µm × 150 µm and 4 µm × 10 µm were compared with a conventional planar contact without recess etching. The localised recess patterns did not provide an improvement in contact resistance compared with the conventional planar contact, which produced the lowest contact resistance of 0.81 Ω·mm among the structures investigated. These results demonstrate that, under the processing conditions used in this work, the introduction of the investigated localised recess patterns did not improve the Ohmic contact resistance. Si ion implantation was subsequently investigated as an approach for reducing Ohmic contact resistance. Blanket Si implantation was applied to GaN/AlGaN/GaN and AlN/GaN heterostructures, followed by high temperature activation and Ohmic contact formation. Low contact resistances were obtained from the implanted structures, with the implanted AlGaN/GaN heterostructure achieving Rc values of approximately 0.10–0.14 Ω ⋅ mm without post metallisation annealing. For the implanted AlN/GaN heterostructure, a minimum Rc of 0.46 Ω ⋅ mm was obtained following post metallisation annealing at 800 °C for 30 s. The effects of implantation activation, surface encapsulation and post metallisation annealing were also investigated as part of the process development. Building on the blanket implantation study, a selective area Si ion implantation process was developed to enable implantation to be confined to defined Ohmic contact regions. The process was applied to an available n-doped GaN capped AlN/GaN heterostructure, allowing implanted and un-implanted regions to be directly compared on the same sample. The implanted region exhibited a contact resistance of 0.14 Ω ⋅ mm, compared with 0.30 Ω ⋅ mm in the un-implanted region, corresponding to a reduction of approximately 53.5%. The corresponding sheet resistance decreased from 750 to 119 Ω/□. These results demonstrate the reduction in Ohmic contact resistance achieved through Si ion implantation and the applicability of selective area implantation to device fabrication. The final experimental study investigated the influence of recess-to-metallisation positioning on Ohmic contact resistance using aligned, overlap and gap designs. Overlap and gap distances of 2, 3 and 5 µm were investigated. Increasing the recess-to-metallisation overlap progressively reduced the extracted contact resistance, with the 5 µm overlap producing the lowest Rc of 0.95 Ω ⋅ mm among the investigated designs. In contrast, introducing a gap between the recessed and metallised regions resulted in a substantial increase in contact resistance. An optimum overlap distance was not established, as Rc continued to decrease up to the maximum investigated overlap of 5 µm. Overall, the results demonstrate that Ohmic contact resistance in III-nitride heterostructures is strongly influenced by recess patterning, Si ion implantation and recess-to-metallisation positioning. In particular, the ion implantation studies demonstrate the effectiveness of this approach for achieving low-resistance Ohmic contacts, while the development of selective-area implantation demonstrates how the implantation process can be confined to defined contact regions for integration into device fabrication. The recess studies further highlight the importance of the extent of recessing and the positioning of the Ohmic metallisation relative to the recessed region. Together, these findings contribute to the development and understanding of fabrication approaches for achieving low-resistance Ohmic contacts in IIInitride electronic devices.

Degree

thesis:*
Level dc:type.qualificationlevel
PhD
Grantor dc:publisher.institution
University of Glasgow
Year dc:date.issued
2026

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Iloke, Joel Idor

Subjects

dc:subject × 1

Rights

Language dc:language
en

Identifiers

dc:identifier.*

Chain of custody

source
Harvested from
University of Glasgow
Base URL
theses.gla.ac.uk/cgi/oai2
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Iloke, Joel Idor. Development of low-resistance ohmic contacts in GaN heterostructures using silicon Ion implantation. PhD thesis, University of Glasgow, 2026. https://doi.org/10.5525/gla.thesis.86342