National Technical University of Athens (NTUA)
Λεπτά υμένια πορώδους αλουμίνας σε υπόστρωμα πυριτίου: παρασκευή του υλικού, ιδιότητες, εφαρμογές
Abstract
dc:descriptionIn this thesis, the self-assembled electrochemical growth of very thin (in the range of 20 to 750 nm) compact and porous alumina films on a silicon substrate was investigated in detail. The growth of such films on a silicon substrate, instead of an Al foil, conventionally used in the literature, opens important new possibilities for their use in several applications in nanoelectronics, nanophotonics and sensors. Their structural characterization was investigated by scanning and transmission electron microscopy (SEM, TEM), including a detailed study of the alumina interface with silicon. Electrical measurements were used to characterize the alumina interface with silicon. An application of the porous anodic alumina (PAA) films as masking material for growing highly ordered hexagonally arranged two-dimensional (2-D) arrays of SiΟ₂ nanodots on the silicon substrate was also developed. Silicon nanopatterning using PAA films was investigated and applied in the growth of 2-D arrays of self-assembled monodispersed silicon nanocrystals on Si, at very high densities. For the fabrication of compact anodic alumina films, an electrolytic solution of citric acid was used for the first time in the literature. Al films with thickness in the range of 10 to 50 nm were anodized. The obtained compact alumina films had a final thickness proportional to the anodization voltage (~ 1-1.2 nm/V). In the case of PAA films, Al films with thickness ranging from 10 to 500 nm were used, that were anodized either in sulphuric or in oxalic acids. By carefully tuning the anodization conditions and the Al film thickness, PAA films with thickness in the range of 20 to 750 nm, pore diameter in the range of 5 to 40 nm and pore density from 10¹⁰ to 6.2x10¹¹/cm² were achieved. To our knowledge, this is the first time that PAA films thinner than 400 nm are mentioned. The differences in PAA films grown on Si compared with those grown on Al was also investigated in detail. Two main differences were found: first, the barrier-layer does not have the usual scalloped appearance that is observed in the case of the Al substrate, but an inversed curvature and a cavity below each pore is observed on silicon for all film thicknesses. Secondly, the current density versus anodization time curve shows a different behaviour in the equilibrium phase, since in the case of the silicon substrate its duration is not externally controlled, but it depends on the thickness of the Al film used. As this thickness decreases, the duration of this phase decreases down to few seconds. This occurs because in this case the anodization procedure is completed very quickly, in less than a minute. With the reduction of the Al film thickness, the optimum anodization conditions for alumina growth were different due to voltage breakdown effects. As a result, lower pore diameters and inter-pore distances were achieved, resulting in much higher pore densities, compared to the thicker films. The effect of aluminum pre-annealing before anodization and the use of an Al (1% Si) alloy in the place of pure aluminum, were also investigated. The use of PAA films as masking layers in nanopatterning the silicon substrate was investigated in detail. Both oxidized and non-oxidized Si surfaces were patterned. The proposed new nanopatterning technique offers a low-cost, simple and fast technique for fabricating sub-lithographic structures on Si. The nanopatterned SiO₂ films were found to have high electronic interface quality, equivalent to that of flat thermal oxides. The self-assembly of silicon nanocrystals on the nanopatterned surfaces by low pressure chemical vapour deposition was investigated in detail. Depending on the exact patterning of the substrate, the nanocrystals were grown either homogeneously on the whole surface, or selectively on specific areas, while their size was in the range of 6 to 30 nm. Their density was above 5x10¹¹/cm² in all cases.
Degree
thesis:*- Grantor dc:publisher
- National Technical University of Athens (NTUA)
- Year dc:date
- 2008
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Kokonou, M.
- Κοκόνου, Μαρία
Subjects
dc:subject × 20- Πορώδης αλουμίνα
- Συμπαγής αλουμίνα
- Υποστρώματα, πυριτικά
- Σχηματοποίηση
- Νανοκρυσταλλίτες
- Ηλεκτροχημεία
- Νανοτεχνολογία
- Μήτρα για ανάπτυξη νανοδομών
- Porous alumina
- Compact alumina
- Silicon substrate
- Patterning
- Nanocrystals
- Electrochemistry
- Nanotechnology
- Template for nanostructures
- Φυσικές Επιστήμες
- Φυσική
- Natural Sciences
- Physical Sciences
Rights
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/16652