University of Patras
Σύνθεση ρεαλιστικών προτύπων πρόδρομων καταλυτικών συστημάτων Ziegler-Natta και διερεύνηση της επίδρασης του παράγοντα αλκυλίωσης: Μελέτη με φασματοσκοπία φωτοηλεκτρονίων από ακτίνες-Χ
Abstract
dc:descriptionZiegler-Natta (ΖΝ) catalysts are used for the industrial polymerization of olefins. The titanium based ZN catalysts are usually supported on MgCl2 and/or SiO2. Their study at a molecular level is a particularly difficult task due to their sensitivity to oxygen and humidity. In the patent literature, where the synthesis of these catalysts is described, there is no justification for the choice of the catalyst’s components and even today there is no satisfactory description of the catalyst while fundamental questions such as the role of the support, the surface concentration and the oxidation state of titanium, the chemical composition and the role of the co-catalyst, remain unanswered. In the frame of the present thesis, realistic model Ti-based ZN catalysts supported on SiO2 are prepared. The term “realistic” means that the preparation conditions of the model catalysts resemble those of the real industrial catalysts while, the models, are compatible with the use of surface sensitive spectroscopies for their study at a molecular level. A Si(100) wafer, covered with a thin native oxide layer, was used as a flat substrate. The deposition of the pre-catalyst’s components (MgCl2, TiCl4) was done by their solutions or from the gas phase. The pre-catalyst models were activated by triethylaluminum (AlEt3) and tested under reaction conditions. The models were studied mainly by X-ray Photoelectron Spectroscopy while some additional information was obtained by Raman and Secondary Ion Mass Spectroscopies. It was found that titanium chloride is anchored on the oxide’s surface by bonding between titanium atoms and oxygen from the surface hydroxyls. At the same time, chlorine atoms act as bridges between magnesium and titanium atoms. Activation of the procatalyst by AlEt3 vapors showed that the changes at the surface composition depend on the amount of chlorine on the surface. Furthermore, when unreacted hydroxyl groups exist on the surface then AlEt3 molecules form bimetallic complexes with the chemisorbed TiClx species. On the other hand, when there are no unreacted species the procatalyst’s activation takes place via direct replacement of chlorine atoms by ethyl groups. Testing of the catalytic models under ethylene and/or propylene reaction conditions showed their poor catalytic activity, as expected due their small catalytic surface area (1cm2), the contamination of which, causes the de-activation of a big percentage of active sites. From the XPS results it was estimated that the surface of the catalytic models was covered by an ultrathin polymer layer (about one monolayer) while the combination of optical microscopy and micro-Raman Spectroscopy revealed the existence of a small number of large (30-50μm) polymer particles on the surface. Furthermore, preliminary SIMS measurements showed some evidence that the polymer grows on top of the active sites that remain anchored at the interface between the polymer and the catalyst’s surface.
Degree
thesis:*- Grantor dc:publisher
- University of Patras
- Year dc:date
- 2006
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Ntais, Spyridon
- Νταής, Σπυρίδων
Subjects
dc:subject × 17- Κατάλυση
- Επιφάνειες
- Φασματοσκοπία φωτοηλεκτρονίων από ακτίνες - Χ (XPS)
- Επιφανειακή ανάλυση
- Χλωριούχο μαγνήσιο
- Χλωριούχο τιτάνιο
- Πολυμερισμός ολεφινών
- ZIEGLER-NATTA CATALYSTS
- X-ray photoelectron spectroscopy
- Surfaces
- Magnesium chloride
- Titanium chloride
- Olefin polymerization
- Φυσικές Επιστήμες
- Χημεία
- Natural Sciences
- Chemical Sciences
Rights
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/18133