Back to search

Aristotle University Of Thessaloniki (AUTH)

Υπολογιστική και πειραματική μελέτη για βέλτιστο σχεδιασμό εναλλακτών θερμότητας τύπου πλακών

Abstract

dc:description

The scope of this dissertation is to suggest a general method for the optimal design of a plate heat exchanger (PHE) that complies with the principles of sustainability. A CFD code is employed to construct virtual PHE channels and to simulate the heat transfer rate and pressure drop in this type of equipment. As the validity of the CFD code must be checked, two model plate heat exchangers have been constructed and used as experimental set-ups. The first experimental set-up comprises an orthogonal channel bearing corrugations on one side only, while the second comprises two complete fluid paths of a typical PHE, one for the hot and one for the cold fluid flow. A two-equation turbulence model, namely the SST (Shear Stress Transport) is used for the simulation. The Nusselt number values, Nu, that have been calculated using the CFD simulation results are found to be in very good agreement with the experimental data and with limited data in the literature. Small deviations in the calculation of friction factor values, f, can be attributed to the small differences in the shape of corrugations. The comparison of experimental data from the CFD simulations led to the safe conclusion that the CFD code can be used as a valid and reliable tool for predicting the thermo-hydraulic characteristics of the flow inside the narrow channels of a PHE. The next step of this thesis was the quest for the values of the PHE design parameters that optimize the performance of this type of equipment. Four of the design parameters refer to the geometrical characteristics of the corrugation herringbone pattern, while the Reynolds number, Re, is chosen as the fifth design parameter. The Box-Behnken technique is employed as a Design of Experiments (DOE) method to limit the number of simulations needed. Results from the simulations were used thereafter to express correlations for the Nu and f using Response Surface Methodology (RSM). The proposed correlations are then used for estimating the geometrical design parameter values that optimize an objective function. This objective function linearly combines heat transfer augmentation with friction losses, using a weighting factor that accounts for the relative cost of energy. It is shown that the optimal performance of a PHE is achieved when secondary flow due to the corrugations is dominant. As the weighting factor increases meaning that the friction losses play a very important role, the optimal PHE should cause small pressure drop. Finally, using the new generalized correlations for Nu and f, a design algorithm is proposed for the calculation of the optimal corrugation geometry or the selection of an appropriate pre-fabricated PHE plate, complying with the principles of ecological and economic sustainability.

Degree

thesis:*
Grantor dc:publisher
Aristotle University Of Thessaloniki (AUTH)
Year dc:date
2008

Author and committee

dc:creator, dc:contributor.*
Authors dc:creator
  • Kanaris, A.
  • Κανάρης, Αθανάσιος

Subjects

dc:subject × 16

Rights

Language dc:language
gre

Identifiers

dc:identifier.*
Identifier
10.12681/eadd/18937

Chain of custody

source
Harvested from
Greek National Archive of PhD Theses
Base URL
phdtheses.ekt.gr/eadd_oai/request
Last updated
2026-11-18
Source record
OAI-PMH GetRecord
citation

Kanaris, A.; Κανάρης, Αθανάσιος. Υπολογιστική και πειραματική μελέτη για βέλτιστο σχεδιασμό εναλλακτών θερμότητας τύπου πλακών. Aristotle University Of Thessaloniki (AUTH), 2008. http://hdl.handle.net/10442/hedi/18937