Aristotle University Of Thessaloniki (AUTH)
Διερεύνηση εφαρμογής μεταλλικών αφρών σε διατάξεις μετεπεξεργασίας καυσαερίου κινητήρων diesel
Abstract
dc:descriptionThe present thesis studies the possibility of using metal foam in diesel exhaust aftertreatment systems. The introductory section describes the properties of the metal foam and makes a comparison with the ceramic materials used as substrates of aftertreatment devices. In order to introduce the non-familiar reader, the first chapter includes a short description of the Diesel Oxidation Catalyst (DOC) and the Diesel Particulate Filter (DPF). The second section studies the use of metal foam as a substrate for DOC applications. For this purpose, a customized small scale experimental setup was used for fundamental investigations. The effect of exhaust flow rate on catalytic activity and the capacity of hydrocarbon adsorption was thoroughly investigated. Experimental research went on to clarify the effects of coating characteristics (Pt and washcoat loading, pore size, coating method) on conversion efficiency. The experience from fundamental investigations was used to develop a number of prototype foam catalysts. The prototypes were experimentally evaluated on an engine bench to define the effect of exhaust flow rate on catalytic activity and a direct comparison was done with a cordierite flow through DOC. Various catalytic coatings were evaluated to select the most suitable for DOC applications. Finally, the prototypes and the ceramic DOC are evaluated on a diesel vehicle over legislated driving cycles. The next section studies the use of metal foam as a substrate for DPF applications. Fundamental investigations were carried out regarding the filtration efficiency, pressure drop, soot loading distribution, soot compression and blow off. Based on that experience, a number of prototype foam filters were developed. All prototypes were tested according to the same evaluation procedure for comparison reasons. The target of the evaluation was to characterize the filters in terms of filtration efficiency, pressure drop, soot compression and maximum soot loading for safe regeneration. A first attempt was done to find an inverse calculation of soot loading given the exhaust flow rate, temperature and the pressure drop of the filter. In order to reduce NO2 slip, a new filter design was implemented and tested. All prototypes were tested to evaluate their catalytic efficiency. The same evaluation procedure was carried out with two SiC wall flow filters for comparison. Finally, the foam and ceramic filters were installed on a modern diesel vehicle and were tested over legislated driving cycles. Selected prototypes were tested on real road driving conditions. The last chapter of the thesis focuses on the evaluation of a complete foam aftertreatment system which consisted of a close coupled precatalyst and an underfloor particulate filter. This system replaced the original one (which had precatalyst and a main catalyst) on a Euro 4 diesel vehicle without any engine modifications. The target was to investigate the ability of the foam system to reduce the gaseous and soot emissions below the Euro 4 and Euro 5 limits. Emission measurements were carried out over NEDC driving cycles according to the legislated method, but also complementary instantaneous measurements were done regarding both gaseous and particle mass and number emissions. The main points of attention are the CO and hydrocarbon reduction efficiency, the effect of the new system on NO2/NOx ratio and total NOx emissions, precatalyst and filter ΔP and fuel consumption. The most important aspect of the evaluation measurements was the soot mass and number emissions due to the very low limit that will be set by the Euro 5 standards. After the end of evaluation over the driving cycles, the foam system was tested under real road driving conditions in comparison with a SiC wall flow filter.
Degree
thesis:*- Grantor dc:publisher
- Aristotle University Of Thessaloniki (AUTH)
- Year dc:date
- 2009
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Katsaounis, Dimitrios
- Κατσαούνης, Δημήτριος
Subjects
dc:subject × 16Rights
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/20502