National Technical University of Athens (NTUA)
Ανάπτυξη ηλεκτρομαγνητικών τεχνικών μη καταστροφικών δοκιμών σε μαγνητικά μεταλλικά υλικά
Abstract
dc:descriptionChanges in the stress state of the material during the action of external force or after a certain mechanical history, result in microstructural alterations, with the most important being the generation and propagation of dislocations which form areas of different dislocation density that may consist possible crack starting points. The generated stress field is directly related to the characteristics of the minor magnetic hysteresis loops, from the linear area of the magnetization curve to the saturated magnetic loop, in quasi-static measurement conditions. The same effect is represented to the Barkhausen noise, a phenomena that reflects to the number of the irreversible magnetic events during the magnetization procedure. Consequently, it is possible to correlate the changes of the magnetic properties with the degree of deformation, taking account the known initial magnetic anisotropy of the magnetic material, and estimate non destructively the probability of material failure. The measurements of magnetic hysteresis loops were realized in an hysteresiograph which was designed and developed in the laboratory. The set up is based on the principle of the closed magnetic circuit, where the receiving coil is winded in the material to be measured and the excitation is realized through a coil surrounding either to the material to be measured or to the core (Π shape) that is used to close the magnetic circuit. Experimental procedure in the measurement of magnetic hysteresis loop and Barkhausen noise as a function of the plastic deformation of the specimens is divided in to measurements under uni-axial stress (on-line) and in to measurements after unloading the specimens. Moreover concerning the set up arrangement it is sub-divided to the case that the excitation is taking place with the use of an electromagnet (in the Barkhausen noise this is a point measurements) and to the case that this is accomplish through a surrounding coil. As a material for testing it has been chosen a steel of very low carbon content (Armco steel) which after scanning electron microscopy proved to contain also a small percentage of precipitates (some steel carbides). After initial magnetic softening of the material (1-5 MPa), we observe a tendency of the material to a further magnetic softening almost until the yield proof strength at 170-175 MPa, and then a reversal to magnetic hardening. This behavior is expected according to the magnetic theory and is explained, for the positive magnetostrictive materials, by a change of block wall orientation from 90° to 180°, which have higher mobility in elastic region of the stress-strain diagram. The magnetoelastic energy is responsible for this behavior which can be considered as an effective field. Changes of the Barkhausen noise signal and its parameters are affected more by the value of external load and no tof the degree of deformation. Moreover it is pointed that for deformation above 0,7% (respective stress equals 175 MPa) the slope of count data divides the diagram in two different reasons as the case of coercive field in magnetic hysteresis loop. Moreover, it is demonstrated that point measurements can give information about the local distribution of material stresses. It is a fact that the methods presented in this thesis can be used complementary in order to assure, under specific circumstances, the real representation of the magnetic state of the material which is related to the mechanical behavior and determines the possibility of safe usage in constructions.
Degree
thesis:*- Grantor dc:publisher
- National Technical University of Athens (NTUA)
- Year dc:date
- 2009
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Kosmas, Konstantinos
- Κοσμάς, Κωνσταντίνος
Subjects
dc:subject × 12Rights
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/23322