Aristotle University Of Thessaloniki (AUTH)
Ανάπτυξη καταλυτών Pd-περοβσκίτη για οχήματα φυσικού αερίου
Abstract
dc:descriptionPassenger cars are the main emitters of CO, hydrocarbons and NOₓ. The use of three way catalytic converters significantly contributed in the reduction of the atmospheric pollution problem. Nevertheless, cars are still the most important polluting agent among means of transport, because of the continuous increase of their fleet. Efforts to enhance catalytic activity and thermal durability by using metal oxides additives as promoters, were not effective. Increase in catalytic performance and retention of high catalyst activity during long-term use, in order to accomplish lower emissions for longer periods, can be achieved only by increasing the precious metal content. However, the implied increase in the converter’s cost, not only causes an increase in the total cost of the vehicle, but also, discourages the replacement of the converter when it deactivates. Natural gas, as a fuel for vehicles operating under stoichiometric air/fuel ratio, exhibits a series of environmental, technical and economic advantages, when compared to gasoline. However, the presence of CO, CH₄ and NOₓ in the exhaust of natural gas vehicles demands the use of a catalytic converter. Moreover, because of the stability of methane molecule, conventional three way catalytic converters are insufficient. Currently used commercial three way catalysts in natural gas vehicles, are usually trimetallic (Pd, Pt, Rh), contain large amounts of noble metals (300 g ft⁻³) and, consequently, are very expensive. Only a few solutions are proposed in literature references, which, mainly, focus on efforts to develop Pd-only catalysts or on promoting catalytic activity by the use of additives. The present study focuses on the development of new, highly active and durable three way catalytic converters for natural gas vehicles, with simultaneous minimization of their noble metal content. The developed active phases consist of perovskite type oxides, which contain small amount of Pd. They are described by the general formula LakMnmAnPdxOz, with, A=Ce, Mg, Zr, k+m+n=2, n=0,00, 0,24 and x=0,025, 0,05, 0,1, 0,2. The effect of the following parameters on the perovskite catalytic activity was studied: • Preparation method: the methods solution combustion synthesis, spray pyrolysis and a combination of the solution combustion synthesis and sol-gel methods, were applied for the preparation of the perovskite-type oxides. The effect of varying some parameters in the aforementioned preparation methods was also investigated in order to obtain materials with sufficient specific surface areas and to achieve adequate dispersion of Pd. • Thermal treatment: the Pd/perovskite active phases were subjected to thermal treatments for several hours, at different temperatures and at different environments, in order to determine the optimum activation conditions. • Active phase composition: this parameter was investigated either by partially substituting the A or B cations with Ce, Mg and Zr, or using nonstoichiometric ratios of A/B cations, or varying the Pd content (x in the general formula). • Pd oxidation state transitions: the catalytic activity variations of the produced perovskites were studied at low and intermediate temperatures, in order to investigate the possibility of the existence of optimum operation temperature ranges. Moreover, various characterization techniques were applied and the obtained results were used for the optimization of the investigated parameters. The three way performance of the most promising active phases was studied in detail, under fully simulated natural gas vehicles exhaust conditions. Τhe effect of hydrothermal treatment at 950°C for several hours was investigated at stoichiometric numbers representative of natural gas vehicles operation. The effect of SO₂ poisoning after several hours of exposure, was studied as well. The catalytic activity of the Pd/perovskite phases was also studied under simulated gasoline vehicles exhaust conditions, in order to determine their ability for use in natural gas and gasoline bi-fuel vehicles. The evaluation of their three way performance was carried out via comparison to a currently used –Pt, Pd, Rh– commercial catalyst, containing an almost threefold higher noble metal load. Finally, the active phases were fully characterized for the investigation of the activation and deactivation mechanisms. The results obtained, indicate that the Pd/perovskite active phases are promising candidates for three way catalysts in stoichiometrically operating natural gas fuel vehicles, despite their almost threefold lower amount of noble metal load, compared to a currently used commercial catalyst.
Degree
thesis:*- Grantor dc:publisher
- Aristotle University Of Thessaloniki (AUTH)
- Year dc:date
- 2010
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Tzimpilis, Evangelos
- Τζιμπιλής, Ευάγγελος
Subjects
dc:subject × 19- Ατμοσφαιρική ρύπανση
- Οχήματα φυσικού αερίου
- Οχήματα βενζίνης
- Καταλύτες Pd
- Καταλύτες Pd/Περοβσκίτη
- Μέθοδος παρασκευής
- Γήρανση
- Δηλητηρίαση με SO2
- Air pollution
- Natural gas vehicles
- Gasoline vehicles
- Pd catalysts
- Preperation method
- Ageing
- SO2 poisoning
- Επιστήμες Μηχανικού και Τεχνολογία
- Επιστήμη Χημικού Μηχανικού
- Engineering and Technology
- Chemical Engineering
Rights
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/23670