National and Kapodistrian University of Athens
Μελέτη εναλλακτικών πηγών πρώτων υλών για την παραγωγή χαρτιού
Abstract
dc:descriptionFiber dimensions and lignin and cellulose content of various highly productive, non-wood plants and agricultural residues were examined to assess their suitability for paper production. Plants like kenaf (Hibiscus cannabinus L.) and giant reed (Arundo donax L.) internodes gave very good derived values, especially slenderness ratio, which is directly comparable to some softwood and most hardwood species. Thus, the pulp from the above species is expected to produce newsprint, writing, printing and wrapping papers of good quality. Cotton (Gossypium hirsutum L.) stalks, miscanthus (Miscanthus x giganteus) and switchgrass (Panicum virgatum L.) have shorter fibers resulting to poorer flexibility and Runkel ratios, but still satisfactory slenderness ratios. Pulp produced from these species can be used in the production of newsprint paper or can alternatively be mixed with conventional pulp to produce papers of various grades. Finally, fibers from olive tree (Olea europea L.) and almond tree (Prunus dulcis L.) prunings presented relatively short and thick fibers producing the poorest derived values among all the species examined. Pulp from these species is expected to have relatively low mechanical strength and can only be mixed with conventional pulp in relatively low (≤20%) ratios. Fiber dimensions did not differ significantly within each species, when samples from different stalks/branches or different positions (base, middle top) were examined. The only exception were cotton stalks, where those differences did not have any significant effect on fiber derived values. Chemical analysis of the plant raw materials revealed satisfactory levels of α-cellulose content (close to 40%) and (Klason) lignin content (<30%) compared to those of hardwoods and softwoods. Relatively increased (>25%) lignin content in miscanthus, switchgrass and almond prunings may require additional pulping time and chemical charge compared to those of other non-wood raw materials. Analysis of samples at various heights/lengths of the plant materials showed that lignin and cellulose content depends on tissue maturity, but does not change significantly within each species. Finally, the cost of non-wood fibers from the above species can be at least 40-50% lower than that of conventional softwood and hardwood pulp. This could favour the establishment of new, middle-sized papermills in the Greek province along with a shift to new, more profitable non-wood plant cultivations. According to the findings of paragraph 1, kenaf (Hibiscus cannabinus L.) was selected as the most promising plant for paper production; thus, it was experimentally cultivated with the use of sewage sludge (130 tn/ha) and water from a municipal sewage treatment plant in order to assess their potential to replace conventional fertilisation (100 Kg N/ha, 75 Kg P₂O₅/ha and 75 Kg K₂O/ha). Tap water and treated wastewaters were used for irrigation in quantities corresponding to 6,500 m³/ha. Four different treatments were applied as follows: one with wastewater irrigation and conventional fertilisation, one with wastewater irrigation and sewage sludge fertilisation, one with tap water irrigation and sewage sludge fertilisation and one with tap water irrigation and conventional fertilisation. The dry plant biomass collected in the final harvest (140 days after plant emergence) from the four plots was 12.2 tn/ha, 12.6 tn/ha, 12.4 tn/ha and 12.9 tn/ha respectively. These differences were not statistically significant (ANOVA, P<0.05) and, therefore, it was concluded that the use of municipal wastes had similar effects on dry biomass production with that of conventional fertilisation. An earlier harvest (125 days after plant emergence) gave an 11.3% lower dry biomass on average, and this difference was statistically significant between the two harvests (Tukey’s SR test, P<0.05). Premature harvest may lead to significant biomass losses, so the plant must be collected during its technological maturity stage. A Pearce test gave a strong (0.93) correlation between dry biomass and stalk height, but a weaker one (0.76) for dry biomass and stalk diameter. There was not any statistically significant difference among the four treatments and between the two harvests as far as fiber dimensions and their derived values (indices) are concerned. On the other hand, there was a statistically significant higher cellulose and lignin content in the second harvest than that of the first, but the differences were not significant among the four treatments. Freshwater algal biomass and orange and lemon peels were assessed as tissue paper supplements. Cellulose and hemicelluloses content of algal biomass was 7.1 % and 16.3 % respectively, whereas for citrus peels cellulose content ranged from 12.7 % to 13.6 % and hemicelluloses content from 5.3 to 6.1%. For all materials, lignin and ash content was 2% or lower rendering them suitable for use as paper pulp supplements. The addition of algal biomass to paper (50% softwood - 50% hardwood) pulp at proportions of 2.5% to 10% significantly increased its mechanical strength probably due to the extra binding forces resulting from the proteins and chitin of the algal cells. However, brightness severely deteriorated due to chlorophyll, which acts as a natural green dye. The addition of citrus (orange and lemon) peels in paper pulp had no effect on breaking length, increased bursting strength and decreased tearing resistance. Brightness was negatively affected at proportions of 10%, because citrus peel particles behave as coloured pigments. The cost of both materials is about 45% lower than that of virgin conventional pulp, resulting in a 0.9% to 4.5% reduction in final paper price, upon their use as supplements in tissue paper manufacture.
Degree
thesis:*- Grantor dc:publisher
- National and Kapodistrian University of Athens
- Year dc:date
- 2007
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Ververis, Charalambos
- Βέρβερης, Χαράλαμπος
Subjects
dc:subject × 11Rights
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/23831