National Technical University of Athens (NTUA)
Three-dimensional thermo-mechanical modeling of austenitic stainless steel welding
Abstract
dc:descriptionIn the present thesis the numerical simulation of the austenitic stainless steel welding process is investigated via the finite element method. In order to proceed to the simulation of the thermo-mechanical process of austenitic stainless steel, the process itself and the material must be carefully studied. The knowledge and understanding of the material behavior during the heating by the welding arc, but also upon cooling, is crucial for the construction of the model, the accurate implementation of the thermal load and the prediction of the thermo-mechanical response of the welded joint. In order to acquire such knowledge, a series of welding experiments were conducted through the butt-welding of austenitic stainless steel plates with various dimensions. In-situ measurements of the thermo-mechanical response, along with stress measurements and metallographic investigation in the as-welded condition, provided sufficient information, thus allowing the accurate numerical modeling of the welding process. The complete insight in the case of the welding process investigation is achieved mostly with the construction of three-dimensional models. The thermo-mechanical analysis of solid models with the finite element method is a time-consuming process in comparison to two-dimensional analyses, since a much larger number of nodes and elements are required for the construction of the solid model. The required time for a solution to be achieved has been decreased with the ongoing improvement of computational efficiency of personal computers. However, efforts are focused on various techniques that would decrease computational time of three-dimensional analyses mostly in multi-pass welding simulation, without any sacrifice in the accuracy in prediction capability. Thus, in the present thesis a series of numerical welding simulations are presented where the accuracy of the predicted results is evaluated and techniques to minimize the computational time are employed. The employment of the “Grouping” technique clearly shows that accurate results can be acquired with a 35% reduction of computational time.
Degree
thesis:*- Grantor dc:publisher
- National Technical University of Athens (NTUA)
- Year dc:date
- 2010
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Kyriakongonas, Andreas
- Κυριακόγγονας, Ανδρέας
Subjects
dc:subject × 20- Πεπερασμένα στοιχεία
- Θερμομηχανική μοντελοποίηση
- Παραμένουσες τάσεις
- Εκτός επιπέδου παραμόρφωση
- Θερμοκρασιακοί κύκλοι
- Συγκόλληση πολλαπλών περασμάτων
- Ανοξείδωτοι ωστενιτικοί χάλυβες
- Ομαδοποίηση περασμάτων
- Finite elements
- Thermo-mechanical modeling
- Residual stresses
- Out-of-plane deformation
- Thermal cycles
- Multi-pass welding
- Austenitic stainless steels
- Grouping passes
- Επιστήμες Μηχανικού και Τεχνολογία
- Επιστήμη Μηχανολόγου Μηχανικού
- Engineering and Technology
- Mechanical Engineering
Rights
- Language dc:language
- eng
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/26079