Democritus University of Thrace (DUTH)
Διερεύνηση και βελτίωση των κριτηρίων ενεσιμότητας αιωρημάτων για εμποτισμό εδαφών
Abstract
dc:descriptionThe safe construction and operation of many structures frequently requires improvement of the mechanical properties and behavior of soils by permeation grouting using either suspensions or chemical solutions. Cement suspensions have lower cost and are harmless to the environment but cannot be injected into soils with gradations finer than coarse sands. Therefore, efforts have been made to extend the injectability range of cement suspension grouts by developing materials with very fine gradations, called microfine cements. Toward this end, a laboratory investigation was conducted in order to evaluate the properties and the groutability of suspensions produced using cements of different type and fineness. Specially produced cements combining three types (CEM I, CEM II/B-M and CEM IV/B, according to EN 197-1) as well as four gradations (one ordinary and three finer cements having nominal maximum grain sizes of 40 μm, 20 μm and 10 μm) were used. The properties of suspensions, with water to cement ratios of 1:1, 2:1 and 3:1 by weight, were determined in terms of viscosity, bleeding, set times and unconfined compression strength. A dosage of superplasticizer equal to 1.4% by weight of dry cement was added to all microfine cement suspensions for viscosity reduction. The groutability of cement suspensions were evaluated by conducting one-dimensional injections into different sands using two specially constructed devices.The first apparatus was used for groutability evaluation by performing injections into sand columns of a length equal to 36.5 cm and a diameter equal to 7.5 cm. The injection pressures in this device were limited to a maximum value of 200 kPa. The use of the second apparatus allowed adequate laboratory simulation of the grouting process by injecting cement suspensions into grouting columns having a height of 144 cm and a diameter of 7.5 cm, under a maximum injection pressure of 700 kPa. Six different, clean sand gradations with grain sizes limited between sieve sizes (ASTM E11) Nos. 5 and 10, 10 and 14, 14 and 25, 25 and 50, 50 and 100, and 100 and 200, were used for the production of grouted soils. Every grouted soil consisted of a combination of the previously mentioned sand fractions in certain proportions by weight. Microfine cement suspensions containing a suitable superplasticizer present comparable properties to the ones reported in the literature for similar materials. Groutability of cement suspensions increases with increasing cement fineness and water to cement ratio and is affected by suspension viscosity. Microfine cement suspensions with water to cement ratios of 2:1 and 3:1 can penetrate into medium to fine sands. The presence of a fine sand fraction as low as 10% can drastically inhibit the success of the injection process. Predictions of groutability by conventional groutability ratios are not always confirmed by laboratory injections due to the fact that the effect of significant factors, such as water to cement ratio, grout viscosity and sand density, are not considered. In order to study the effects of the parameters on groutability and permeability of cement suspensions, an alternative approach using fuzzy regression analysis is presented and supported by experimental results. The newly developed approach will help for the more accurate prediction of the penetrability of cement suspensions in granular soils.
Degree
thesis:*- Grantor dc:publisher
- Democritus University of Thrace (DUTH)
- Year dc:date
- 2009
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Christodoulou, Dimitrios
- Χριστοδούλου, Δημήτριος
Subjects
dc:subject × 20- Ενέσεις εμποτισμού
- Αιωρήματα τσιμέντου
- Λεπτόκοκκα τσιμέντα
- Διεισδυτικότητα αιωρημάτων
- Άμμοι
- Κριτήρια ενεσιμότητας
- Ασαφής γραμμική παλινδρόμηση
- Εργαστηριακή διερεύνηση
- Permeation grouting
- Cement suspensions
- Microfine cements
- Penetrability of suspensions
- Sands
- Groutability ratios
- Fuzzy regression analysis
- Laboratory investigation
- Engineering and Technology
- Civil Engineering
- Επιστήμες Μηχανικού και Τεχνολογία
- Επιστήμη Πολιτικού Μηχανικού
Rights
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/26853