Democritus University of Thrace (DUTH)
Αποτελεσματικότητα ενέσεων εμποτισμού εδαφών με λεπτόκοκκα τσιμέντα
Abstract
dc:descriptionΤhe safe construction and operation of many structures frequently requires improvement of the mechanical properties and behavior of soils by permeation grouting using either suspensions or chemical solutions. Cement suspensions have lower cost and are harmless to the environment but cannot be injected into soils with gradations finer than coarse sands. Therefore, efforts have been made to extend the injectability range of cement suspension grouts by developing materials with very fine gradations, called microfine cements. Toward this end, a laboratory investigation was conducted in order to evaluate the properties and the effectiveness of suspensions produced using cements of different type and fineness. More specifically, specially produced cements combining three types (CEM I, CEM II/B-M and CEM IV/B, according to EN 197-1) as well as four gradations (one ordinary and three finer cements having nominal maximum grain sizes of 40 μm, 20 μm and 10 μm) were used. The properties of suspensions, with water to cement ratios (w/c) of 1:1, 2:1 and 3:1 by weight, were determined in terms of viscosity, bleeding, set times and unconfined compression strength. A dosage of superplasticizer equal to 1.4% by weight of dry cement was added to all microfine cement suspensions for viscosity reduction. The effectiveness of cement suspensions were evaluated by conducting one-dimensional injections in different sands placed into grouting columns having a height of 144 cm and a diameter of 7.5 cm, under a maximum injection pressure of 700 kPa. Six different, clean sand gradations with grain sizes limited between sieve sizes (ASTM E11) Nos. 5 and 10, 10 and 14, 14 and 25, 25 and 50, 50 and 100, were used for the production of grouted soils. Every grouted soil consisted of a combination of the previously mentioned sand fractions in certain proportions by weight. The effectiveness of cement suspensions was quantified by conducting unconfined compression, triaxial compression and permeability tests on grouted sand specimens. Strength values up to 14 MPa and permeability reductions up to 5 orders of magnitude can be obtained due to permeation grouting. The results obtained, have shown that w/c ratio, the use of microfine cements, soil grain size and the distance from the injection point are the main factors affecting the improvement of strength and permeability of grouted soil. The friction angle of soil remains unchanged by grouting treatment, which is propably attributed to no disturbance of soil assembly caused by permeation grouting. The obtained Mohr-Coulomb cohesion increase with decreasing w/c ratio and soil grain size and can exceed a value of 2 MPa when soils are grouted with suspensions having water to cement ratio equal to 1:1
Degree
thesis:*- Grantor dc:publisher
- Democritus University of Thrace (DUTH)
- Year dc:date
- 2009
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Droudakis, Alexandros
- Δρουδάκης, Αλέξανδρος
Subjects
dc:subject × 22- Ενέσεις εμποτισμού
- Αιώρημα
- Λεπτόκοκκα τσιμέντα
- Αντοχή σε ανεμπόδιστη θλίψη
- Διαπερατότητα
- Τριαξονική φόρτιση πολλαπλών σταδίων
- Αποτελεσματικότητα
- Συνοχή
- Permeation grouting
- Suspension
- Microfine cements
- Unconfined compression strength
- Permeability
- Multistage triaxial compression testing
- Effectiveness
- Cohesion
- Engineering and Technology
- Civil Engineering
- Materials Engineering
- Επιστήμες Μηχανικού και Τεχνολογία
- Επιστήμη Πολιτικού Μηχανικού
- Μηχανική Υλικών
Rights
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/26879