National Technical University of Athens (NTUA)
Παρασκευή και χαρακτηρισμός μεμβρανών ανοδικής αλουμίνας για τον εμπλουτισμό αερίου σύνθεσης σε υδρογόνο
Abstract
dc:descriptionThe scope of the Doctoral Thesis is the fabrication of meso- and micro-porous anodic alumina membranes at the side cylindrical surface of thin-walled Aluminum tubes, the physicochemical characterization of membrane structure and the development of a practical tool of an overall evaluation of gas separation effectiveness. The main stages of membrane preparation procedure are anodization, chemical and hydrothermal treatment of aluminum tubes. Single-gas permeance and binary gas mixtures selectivity measurements are conducted in a Wicke-Kallenbach device. The porous structure characterization includes Nitrogen Adsorption measurements and Scanning Electron Microscopy images. The aim of simultaneous internal and external anodization is to construct through-hole pore morphology by overcoming chemical treatment. Some trials have been successful, but the reproduction of this kind of membranes presents some difficulty. The application of chemical treatment (ChT) created membranes permeable to gases and caused a severe change of the PSD. Hydrothermal treatment (HT) causes the closure of wide pores and the re-appearance of narrow mesopores and micropores. Furthermore prolonged HT results in pore merging and creation of new porosity. The effects of anodizing conditions were also studied. In general the milder the anodizing conditions (lower current density and electrolyte concentration), the smaller the contribution of viscous flow in total gas flow. In conclusion, pure gas permeation measurements on anodic alumina membranes indicated that the Knudsen flow regime is the dominant mass transfer mechanism. Hydrogen permselectivities on all examined membranes, approach the maximum expected Knudsen value by 50-100%. In the case of binary gas mixtures and in successive separation cycles, it was observed that hydrogen permselectivity, using the same membranes, increases from 0.50 to 0.70 (A cycle), 0.70 to 0.80 (B cycle) and 0.80 to 0.90 (C cycle). However, hydrogen recovery in the permeate gas stream on the single membrane module system is quite low. The optimization of desired gas recovery can be realized by developing multi module membrane systems.
Degree
thesis:*- Grantor dc:publisher
- National Technical University of Athens (NTUA)
- Year dc:date
- 2011
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Vaitsi, Sofia
- Βαΐτση, Σοφία
Subjects
dc:subject × 18- Μικροπορώδεις μεμβράνες
- Ανοδική αλούμινα
- Συνθήκες ανοδίωσης
- Εκλεκτικότητα διαχωρισμού
- διάχυση κατά Knudsen
- Παράγοντας διαχωρισμού
- Ανάκτηση αερίου
- Microporous membranes
- Anodic alumina
- Anodizing conditions
- Selectivity
- Knudsen diffusion
- Separation factor
- Gas recovery
- Επιστήμες Μηχανικού και Τεχνολογία
- Επιστήμη Χημικού Μηχανικού
- Engineering and Technology
- Chemical Engineering
Rights
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/27016