University of Patras
Τρισδιάστατη αριθμητική προσομοίωση συμπεριφοράς επιφανειακού στρεφομένου θεμελίου σε στρωσιγενές υλικό
Abstract
dc:descriptionThe present thesis deals with three dimensional numerical simulation concerning the behavior of rotating surface footings on a layered medium. It is therefore concerned with study of the problem in three dimensions, where, apart from the dip angle β of the layers, the alteration of the strive angle ω, is taken into account. That is, the angle between the direction of the longitudinal axis of the strip footing and the strike of the bedding layers. The main purposes of this investigation is the study of how the angles β and ω influence the bearing capacity, the deformations and the rotations of a surface footing founded on the thin layer medium as well as to compare the numerical analysis with the behavior of relevant physical models. The above was done, in order to prove the capacity of the program PLAXIS 3D to simulate successfully, partly or in total, the previous prementioned parameters. The main results of the thesis are: 1) The maximum load appears to be estimated with precise accuracy according to the type of problem based on an empirical rule, which has been formulated. According to the rule, the maximum load corresponds to the finishing point, of a relatively linear segment on the stress-strain curve. For a given angle β, a general tendency of increasing failure loads is observed when angle ω varies from 0° to 45°. For ω larger than 45°, relatively small variances are noticed. 2) The vertical displacements are generally reduced, as angle β increases from 0° to 90° and the respective values of relative deformations vary from 25% to 5%. Comparing the theoretical and experimental vertical displacements, at the point of failure, it can be concluded that, when angle β varies from 0° to 30°, the convergence is satisfactory. In contrast, for angles β equal or larger than 45°, there was a great divergency. The theoretical displacements were from 30% - 50% smaller, than the respective experimental values.
Degree
thesis:*- Grantor dc:publisher
- University of Patras
- Year dc:date
- 2007
Author and committee
dc:creator, dc:contributor.*- Author dc:creator
-
- Μουλίνος, Γεράσιμος
Subjects
dc:subject × 14- Φέρουσα ιακνότητα
- Θεμέλιο
- Ανισότροπο υλικό
- Στρωσιγενής βραχόμαζα
- Τριδιάστατη προσομοίωση θεμελίου
- Bearing capacity
- Foundation
- Anisotropic materials
- Layered roch mass
- 3D modeling of foundation
- Επιστήμες Μηχανικού και Τεχνολογία
- Επιστήμη Πολιτικού Μηχανικού
- Engineering and Technology
- Civil Engineering
Rights
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/27743