University of Patras
Ανάπτυξη λεπτών υμενίων για χρήση στην ηλεκτροχημική ενίσχυση της κατάλυσης
Abstract
dc:descriptionElectrochemical Promotion of Catalysis (EPOC or Non-Faradaic Electrochemical Modification of Catalytic Activity, NEMCA effect) is a phenomenon where the application of small currents or potentials (±2V) alters the activity and selectivity of catalysts supported on ionic or mixed ionic-electronic conductors and modifies the catalytic activity and selectivity, in a controllable, reversible and to some extend predictable manner. As shown by numerous surface science techniques, including STM, electrochemical promotion is due to electrochemically controlled migration (backspillover) of promoting or poisoning ionic species (Oδ- in the case of YSZ) between the ionic or mixed ionic-electronic conductor and the gas exposed catalytic surface. Although electrochemical promotion has been studied and applied quite successfully for over seventy catalytic systems there has been so far no large scale commercial utilization. This is primarily due to the almost exclusive use of expensive, thick, catalyst films (typically 0.1 μm to 5 μm thick) with metal dispersion below 0.01%. This limitation can be overcome via the use of thin sputtered metal electrodes with metal dispersion exceeding 10%. In the first chapter a detailed analysis of sputtering procedure as a deposition technique is discussed introducing the basic parameters that affect the morphology of the growing film. Magnetron sputtering is a very powerful process which is successfully used widely in many applications, particularly in microelectronics and surface engineering, for the production of films and coatings. In the second chapter is given an introduction to the basic characteristics of Electrochemical Promotion and its origins. The rules that can predict the behavior of a catalytic reaction, during changes in the catalyst work function, are presented. The electrochemical promotion of Pt/YSZ and Pt/TiO2/YSZ catalystelectrodes has been investigated, in the third chapter, for the model reaction of C2H4 oxidation in an atmospheric pressure single chamber reactor, under oxygen excess between 280 and 375oC. It has been found that the presence of a dispersed TiO2 thin layer between the catalyst electrode and the solid electrolyte (YSZ), results in a significant increase of the magnitude of the electrochemical promotion of catalysis (EPOC) effect. The rate enhancement ratio upon current application and the faradaic efficiency values, were found to be a factor of 2.5 and 4 respectively, higher than those in absence of TiO2. This significantly enhanced EPOC effect via the addition of TiO2 suggests that the presence of the porous TiO2 layer enhances the transport of promoting O2- species onto the Pt catalyst surface. This enhancement may be partly due to morphological factors, such as increased Pt dispersion and three-phaseboundary length in presence of the TiO2 porous layer, but appears to be mainly caused by the mixed ionic-electronic conductivity of the TiO2 layer which results to enhanced O2- transport to the Pt surface via a self-driven electrochemical promotion O2- transport mechanism. Also, the use of thin catalytic Pt sputtered electrodes (Pt/YSZ/Au) was examined in the MEPR for the model reaction of C2H4 oxidation. It was found that such thin electrodes are catalytically active and can be electropromoted even under high gas flow rates (25 l/min) or high space velocity (HSV~12000 s-1), close to those that the industrial reactors operate. A single chamber reactor equipped with a Cu/TiO2/YSZ electrode and a monolithic electropromoted reactor (MEPR) with up to 20 thin Cu/TiO2/YSZ plate cells were also used to investigate the hydrogenation of CO2 at atmospheric pressure. In recent years the hydrogenation of CO2 to hydrocarbons has received worldwide attention both as a potential source of renewable fuels and as a potential means of decreasing the overall CO2 emissions. Utilizing the single chamber reactor CO and CH4 was produced with selectivity to CH4 up to 17%. Both positive and negative applied potential significantly enhance the hydrogenation rate and selectivity to CH4. It was found that the addition of small (~0.5kPa) amounts of CH3OH in the feed has a pronounced promotional effect on the reaction rate and selectivity of the Cu/TiO2/YSZ cells. The selective reduction of CO2 to CH4 starts at 280oC (vs 350oC in absence of CH3OH) with near 100% CH4 selectivity at open-circuit and under polarization conditions at temperatures 280–380oC. Utilizing a MEPR equipped with 20 Cu/TiO2/YSZ cells CO, CH4 and C2H4 were produced with selectivities to CH4 and C2H4 up to 80% and 2%. The maximum CO2 conversion reached 40% at 380oC. The addition of small (~0.5 kPa) amounts of CH3OH in the feed has also a pronounced promotional effect on the reaction rate and selectivity to CH4 (near 100%) at open-circuit and under polarization conditions at temperatures 220–380oC. The results show the possibility of direct CO2 conversion to useful products in a MEPR via electrochemical promotion at atmospheric pressure.
Degree
thesis:*- Grantor dc:publisher
- University of Patras
- Year dc:date
- 2010
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Papaioannou, Evangelos
- Παπαϊωάννου, Ευάγγελος
Subjects
dc:subject × 20- Εναπόθεση πλάσματος
- Ηλεκτροχημική ενίσχυση της κατάλυσης
- Υμένια TiO2 σε YSZ
- Οξείδωση αιθυλενίου
- Αναγωγή του CO2
- Ηλεκτρόδια Cu
- Παραγωγή υδρογονανθράκων
- Ενισχυτική δράση μεθανόλης
- Plasma deposition
- Nemca effect
- TiO2 layers on YSZ
- Ethylene oxidation
- CO2 hydrogenation
- Cu electrodes
- Hydrocarbon production
- Promoting role of methanol
- Engineering and Technology
- Chemical Engineering
- Επιστήμες Μηχανικού και Τεχνολογία
- Επιστήμη Χημικού Μηχανικού
Rights
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/28041