National Technical University of Athens (NTUA)
Μορφοποίηση πολυμερικών υλικών: αναλυτική και αριθμητική προσομοίωση
Abstract
dc:descriptionExtrusion is one of the most widely used techniques both for processing and for blending polymers. The main part of production line using the estuary is the die of the extruder. The aim of this doctoral work is the design and optimization of a polymer extrusion die to produce high density polyethylene pipes (HDPE), in order to obtain better uniformity in the velocity of the molten polymer which will lead to increased mechanical strength of the plastic tube.The signal to noise ratio of the polymer at the exit of the die is considered as a flow optimization variable output (objective function), with the aim to be maximized. The optimization parameters are specifically selected geometric characteristics of the extrusion die. A total of six selected optimization parameters were selected, which the length of the output die, the length of the spline at the X axis (X), the maximum amount of spline (S), the position of the maximum as a percentage of X (f), the angle of departure the spline (a) and the angle of termination of the spline (b). Given that the initial and boundary conditions of the flow varies during the production process (editing material, ambient conditions, inlet pressure to the die, etc.) the main variables related to the geometry of the die are examined as well as their effect on the flow (along the output die, geometry of the leg of the spider). The optimization was carried out for a series of simulations using the SolidWorks ® and Comsol ® software packages in conjunction with Taguchi and response surface (RSM) methods. The optimal value of the length of the output matrix is minimal according to the geometric and construction constraints, namely: LOPT = 24 mm. The optimal value of the length of the die leg is the minimum possible under the geometric and construction constraints, namely: XOPT = 30 mm. The optimal values of the thickness of the spider leg (Y) and the maximum of the curve spline (f), are respectively YOPT = 9 mm, fOPT = 0,2 (20 %),aOPT = 5 oand bOPT = 5 o. The static analysis performed in conjunction with the simulation results of the flow showed that the parts of the die in its area of diversion (I) and head of the spider (II), are subjected to the highest mechanical stresses. It seems that the maximum stress generated on the legs of the spider's head, which withstand the exerted pressure from the fluid while supporting the internal components of the extrusion die. The maximum deflection is observed on the male cone head which receives the highest pressure from the fluid.
Degree
thesis:*- Grantor dc:publisher
- National Technical University of Athens (NTUA)
- Year dc:date
- 2011
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Κούζιλος, Γεώργιος
- Kouzilos, Georgios
Subjects
dc:subject × 14Rights
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/28166