Back to search

University of Patras

Σπειροειδής κίνηση και έλεγχος σε μικρο/νάνο-ηλεκτρομηχανικά συστήματα αποθήκευσης πληροφορίας

Abstract

dc:description

The AFM techniques using scanning probes have the capacity not only to observe surfaces in atomic level but also to modify them at a very small scale. This feature motivates the use of these techniques to create storage devices capable of storing data in a much higher density than conventional devices. In various MEMS/NEMS-based data storage technology research projects with probes, the relative trajectory follows a raster pattern or similar. Despite its simple implementation, the aforementioned scanning pattern has significant disadvantages. In this work, an alternative spiral motion topology is proposed. The proposed method can be applied to any system based on scanning probes, such as storage systems and AFM imaging systems. In this work, the case of storage devices with probes is studied, in which the trajectory of the probe with respect to the x/y plane of the storage medium, is the spiral curve of Archimedes. The use of such a spiral trajectory leads to a reference position signal with extremely narrowband frequency content, which slides very slowly in time. For experimental verification, the proposed method of spiral motion was applied on a single probe experimental setup, with read and writes data thermomechanical capabilities on very thin polymer films. The aforementioned inherent properties of the proposed approach enable system designs with improved tracking performance and with non-intermittent, high-speed storage capabilities. Thus, the exploitation of these properties by architectures specifically designed and optimized for the particular reference trajectory is studied, in order to achieve much higher scanning frequencies for the same positioning accuracy. To verify the theoretical analysis, simulation results are presented as well as experimental results from the application of the proposed techniques and architectures in experimental AFM systems with a single probe. In this dissertation the modeling of the thermomechanical storage channel with probes in thin polymer films was also carried out. While the theoretical form of thermomechanically engraved indentations is conical, in practice its form is far from this theoretical model. Hence, a symbol model was developed in respect to the scanning speed during the write process, based on experimental data. This model can be used to properly design the equalization circuits depending on the motion speed of operation. Moreover, the possibility of developing combined architectures of tracking control and symbol timing recovery was also investigated, where the information regarding the scanner speed is provided from the storage medium via symbol timing synchronization circuits. The simulation results confirm this approach and, furthermore, show that, under certain conditions, the system's tracking accuracy is improved. Finally, the performance of the proposed methods in the case of portable storage devices was investigated, where the systems are subjected to external disturbances. As part of this investigation, experimental results were collected and measurements of external disturbances, typical for such devices, were analyzed.

Degree

thesis:*
Grantor dc:publisher
University of Patras
Year dc:date
2012

Author and committee

dc:creator, dc:contributor.*
Authors dc:creator
  • Kotsopoulos, Andreas
  • Κωτσόπουλος, Ανδρέας

Subjects

dc:subject × 32

Rights

Language dc:language
gre

Identifiers

dc:identifier.*
Identifier
10.12681/eadd/28482

Chain of custody

source
Harvested from
Greek National Archive of PhD Theses
Base URL
phdtheses.ekt.gr/eadd_oai/request
Last updated
2026-11-18
Source record
OAI-PMH GetRecord
citation

Kotsopoulos, Andreas; Κωτσόπουλος, Ανδρέας. Σπειροειδής κίνηση και έλεγχος σε μικρο/νάνο-ηλεκτρομηχανικά συστήματα αποθήκευσης πληροφορίας. University of Patras, 2012. http://hdl.handle.net/10442/hedi/28482