Technical University of Crete (TUC)
Αποκατάσταση υδάτων ρυπασμένων από ΒΤΕΧ και ΜΤΒΕ με χρήση φυσικού και τροποποιημένου διατομίτη. Σύγκριση και συνδυασμός με άλλα φυσικά προσροφητικά υλικά.
Abstract
dc:descriptionThe present thesis examines the possibility of using diatomite for typical petroleum contaminants (benzene, toluene, ethylbenzene, xylenes - BTEX, methyl tertiary butyl ether – MTBE, tertiary amyl methyl ether – TAME) adsorption from water, in order to remediate it. The selection of these contaminants was based on the fact that they can be found and co-exist in many contaminated sites, presenting partially different properties and behavior and therefore their removal from underground (mainly) waters represents a frequent problem that needs to be dealt with in a global level. The selection of diatomite as an adsorbent was based on the fact that it is a natural material, it has special properties, it is abundant in many places of the world and it has low cost.For the evaluation of diatomite as an adsorbent of the above mentioned contaminants three samples of different origin were used, in a raw form, as well as in a thermally (at temperatures from 250οC to 1.150 οC) and/ or chemically (using acids and bases) treated form, in order to optimize their characteristics and enhance their adsorption capacity.Through the conduction of batch adsorption experiments, the following were investigated: a. adsorption kinetics, b. adsorption isotherms, c. potential matrix effects, d. potential competitive effects, e. contaminants’ desorption from diatomite and f. diatomite regeneration potentials. In addition, the adsorption of the examined contaminants on two different adsorbents: lignite (raw and thermally treated) and activated carbon, was studied for comparison reasons.Finally, adsorption experiments in columns were conducted, using only diatomite and combination of diatomite and lignite, in an effort to approach diatomite’s adsorption capability under the conditions of flowing water, as they apply in an adsorption filter or a permeable reactive barrier.As it was concluded, diatomite may present significantly different characteristics and properties, depending on its origin and composition (mineral and chemical) and therefore different adsorption capacity, as well. Its composition also determines the influence of any usual treatment (thermal or chemical) on its characteristics and its adsorption capacity.In general, the thermal treatment of all three raw diatomite samples showed that the temperature of 550 oC results in maximization of their adsorption capacity, either through an increase of their specific surface, or by causing favorable physicochemical changes on their surface (e.g. change in the type and the number of existing reactive sites, water desorption, etc.). The chemical treatment of diatomite using strong acids and bases (in combination with thermal treatment or not) achieves excellent purification ofdiatomite, removing any potential admixtures almost totally. However, this purification process does not necessarily leads to an increase in its specific surface, but on the contrary it may reduce it. In any case, the removal of diatomite’s admixtures increases its adsorption capacity, probably because of several changes that are caused on the physicochemical properties of its surface.The adsorption of the selected contaminants on diatomite, even though it can be quantitatively compared to that of other adsorbents (e.g. resins or even some types of activated carbon), that have also been tested, according to the existing literature, it is lower than the one that was determined for the lignite and activated carbon of the present thesis, as well as several other adsorbents of other studies.Despite that, its particularly low cost, compared to that of the other examined adsorbents, may eliminate its indicated inferiority, allowing its use under certain conditions.In conclusion, diatomite represents a sufficiently effective adsorbent of the selected contaminants, even when it does not have the best possible characteristics (e.g. the maximum expected specific surface) and its adsorption capacity can be significantly enhanced by applying relatively simple and inexpensive treatment. The adsorption capacities that were measured in the present thesis, as well as diatomite’s abundance, low cost and regeneration potentials, make its further study very interesting, aiming at determining specific conditions and restrictions on its use in dealing with real water remediation problems, concerning BTEX, MTBE, TAME and probably other petroleum contaminants as well.
Degree
thesis:*- Grantor dc:publisher
- Technical University of Crete (TUC)
- Year dc:date
- 2011
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Aivalioti, Maria
- Αϊβαλιώτη, Μαρία
Subjects
dc:subject × 14Rights
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/32150