Back to search

National Technical University of Athens (NTUA)

Ανάπτυξη και μελέτη δομής και ιδιοτήτων επικαλύψεων νανοϋλικών με τεχνολογίες θερμικού ψεκασμού

Abstract

dc:description

The purpose of the present dissertation was the development and optimization of HVOF and APS thermal spray coatings from nanophased materials, using the Taguchi design of experiments method. The influence of grit–blasting on surface roughness and coating adhesion strength was also studied. Moreover, an evaluation of air quality inside the building of a thermal spray industry was performed.For the Fe–31Mo–2C coatings, the optimized nanophased coating properties meet the current conventional coating specifications. The oxide content was larger in the nanophased coating and the Mo particles were smaller and more widely dispersed. FeO and Fe3O4 were formed during spraying, which act as solid lubricants. The formation of martensitic and amorphous phases were detected, while there were no Fe peaks, thus indicating that the initial powder nanostructure was not maintained in the coating after deposition. The coefficient of friction of the nanophased coating showed an improvement of 30% compared to the respective coefficient of the conventional coating. The wear was initially higher, because of the higher surface roughness, however as the tests evolved, the wear rate was similar for both nanophased and conventional coatings.Regarding the Fe–1,5Cr–1,1C coatings, FeO and Fe3O4 were also formed in this case. The nanostructure was maintained in the coatings, as a result of lower electrical power and higher particle size. The nanophased coating exhibited lower coefficient of friction and wear compared to the conventional one.Regarding the HVOF WC–12Co nanophased coatings, part of the initial powder nanostructure was maintained in the coating. The formation of Co3W3C was observed, because of the dissolution of WC into the Co matrix. The reduction of the particle size of the nanophased powder led to severe decarburization phenomena, similar to the conventional coating. The addition of Al reduced coating porosity, increased microhardness and limited the dissolution of WC to Co3W3C. The coefficient of friction was similar for both the nanophased and the conventional coating, while the addition of Al increased the coefficient. The wear of the coatings was negligible and could not be defined. The abrasive wear of the counter body was lower in the case of the nanophased WC–12Co coating and higher in the case of the conventional coating and showed a linear correlation with the coating microhardness.Regarding grit–blasting, it was found that larger grit size led to higher surface roughness and coating adhesion strength. Finally, results showed that the measured airborne particles and heavy metals concentrations were low and well within the limits set by national and European legislation.

Degree

thesis:*
Grantor dc:publisher
National Technical University of Athens (NTUA)
Year dc:date
2013

Author and committee

dc:creator, dc:contributor.*
Authors dc:creator
  • Petsas, Nikolaos
  • Πέτσας, Νικόλαος

Subjects

dc:subject × 20

Rights

Language dc:language
gre

Identifiers

dc:identifier.*
Identifier
10.12681/eadd/33311

Chain of custody

source
Harvested from
Greek National Archive of PhD Theses
Base URL
phdtheses.ekt.gr/eadd_oai/request
Last updated
2026-11-18
Source record
OAI-PMH GetRecord
citation

Petsas, Nikolaos; Πέτσας, Νικόλαος. Ανάπτυξη και μελέτη δομής και ιδιοτήτων επικαλύψεων νανοϋλικών με τεχνολογίες θερμικού ψεκασμού. National Technical University of Athens (NTUA), 2013. http://hdl.handle.net/10442/hedi/33311