University of Patras
Ανάπτυξη αναλυτικής μεθοδολογίας για την εκτίμηση της ποιότητας των οστών
Abstract
dc:descriptionBone is a composite material characterized by a complicated hierarchical structure. It consists of three phases: inorganic, organic and aqueous. The inorganic is the dominant part accounting 60-65% w/w of bone and is a chemical and structural analogue of the mineral hydroxyapatite [Ca10(PO4)6(OH)2]. It is exactly for this reason that it is called bioapatite or biological apatite. The organic part constitutes about 30% of the weight of bone and its principal component is collagen (type I), which accounts for more than 90% of the weight of the organic phase. Non-collagenous proteins, lipids, cells and other organic substances are also included in the organic part of bone. The remaining 5-10% w/w of bone is water. The composition of bone and particularly the concentrations of bioapatite and collagen (which together exceed 95% w/w of dry bone) play a crucial role in its mechanical properties, including resistance to fracture, stiffness and elasticity. These properties relate to various pathological situations of bone which may cause fractures like osteoporosis –the most frequent metabolic bone disease– osteomalacia, osteogenesis imperfecta and others. For the diagnosis of the above diseases and especially of osteoporosis, measurements of BMD (Bone Mineral Density) is the gold standard. However, nowadays it is a common belief that BMD alone cannot reliably predict the risk of bone fracture. For this reason, a new approach is followed according to which the study of factors that influence the mechanical properties of bone is suggested for diagnostic purposes. Inarguably, the composition of bone appears to be a key factor for the evaluation of risk fracture. Despite the fact that composition of bone has been determined by various analytical techniques, the use of Raman spectroscopy (RS) for this purpose, has been inadequately exploited. The simultaneous analysis of inorganic and organic phase, the minimal or even none requirements for sample preparation and the promising ongoing efforts for the in vivo analysis of tissues, rendered this technique a powerful tool for the study of bones. Taking into account the important advantages of RS and the role of bone composition as a diagnostic parameter, it was attempted to develop a method, based on RS, of quantitative analysis of the composition of bioapatite and collagen in bone. A large number of bovine bone specimens (cortical and trabecular) was collected. Lipids, marrow and the non-collagenous proteins were removed by chemical methods. Some of the specimens were treated with EDTA solutions for the separation of collagen. A second batch of bone specimens was subjected to the removal of organic phase by hydrazine. Afterwards, the effect of chemical purification and of hydrazine treatment on the crystal structure of bioapatite was investigated. X-Ray Diffraction (XRD) measurements revealed that although chemical purification does not have any significant effect, hydrazine treatment induces noteworthy changes of the crystal size and crystallinity of the mineral phase. Further XRD measurements and investigation of bone specimens with infrared spectroscopy unveiled that the observed changes were temperature depended and were due to the removal of CO32- and HPO42- ions from the crystal lattice of bioapatite, caused by hydrazine. A series of standard mixtures was prepared by mixing carefully weighted amounts of the purified bone components and the corresponding calibration curves were constructed. These calibration lines could be used for the quantitative analysis of bone specimens with respect to its content in bioapatite and collagen. The peak at 960 cm-1 of the Raman spectrum of bone was selected as marker of bioapatite (ν1 vibration of ΡΟ43-¬). For collagen two peaks were tested, at 1667 cm-1 (vibration of amide I) and at 2941 cm-1 (vibration of C-H2). For these two peaks both, the height and the integrated areas were used for the construction of the respective calibration curves. Height and area ratios of 960 cm-1/1667 cm-1 and 960 cm-1/2941 cm-1 peaks are proportional to the ratio of mass fraction of bioapatite to collagen. For the models developed, the most accurate was proved to be this one that used the height ratio of 960 cm-1/1667 cm-1 peaks. For comparison reasons, new models were developed based on chemometrics and in particular by using the PLS algorithm. PLS has been proved a powerful method for the analysis of multivariate problems and during the last years there is a growing number of applications in spectroscopy. A broad region of the Raman spectrum was used from 366 cm-1 to 1800 cm-1 and various spectral filters were tested. The best results were obtained for the SNV spectral filter. Following the selection of the optimum model for each of the two different methods of calibration, they were evaluated with the results from other analytical techniques. Various bone specimens were quantified for bioapatite and collagen with the implementation of the developed models and their results were compared with the corresponding results of two other analytical techniques, Atomic Absorption Spectroscopy (AAS) and Thermogravimetric Analysis (TGA). Although analytical results showed good agreement between AAS and TGA, the consensus of the results obtained by RS and that of AAS and TGA was poor. This indicates that the developed methods based on RS were inappropriate. A possible reason for the failure of the above models, which based on RS, could be the selection of amide I vibration for the quantification of collagen. Thus, additional models were constructed using different peaks as collagen markers. The peaks at 855 and 878 cm-1 were selected, which are attributed to vibrations of the amino acids proline and hydroxyproline, respectively. For bioapatite the peak at 960 cm-1 was used. The quantitative analysis was developed using heights and integrated areas of the selected peaks. Comparison between the models showed that the best results were obtained by the model that takes into account the sum of the heights at 855 cm-1 and 878 cm-1. Comparison of this model with the results obtained from AAS and TGA showed excellent agreement with respect to the content of bone specimens in bioapatite and collagen. The calibration equation derived for this model is: where: Hi is the height of the peak at the i wavenumber of the Raman spectrum and ΧΒ, ΧC are the % mass content of bioapatite and collagen in the bone specimens respectively.
Degree
thesis:*- Grantor dc:publisher
- University of Patras
- Year dc:date
- 2011
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Karampas, Ioannis
- Καραμπάς, Ιωάννης
Subjects
dc:subject × 15Rights
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/34154