Back to search

University of Patras

Επίδραση της σύστασης και της τροποποίησης με Zn ή Cu νανοδομημένων καταλυτών Ni/Al2O3 στη δραστικότητα τους για τη μετατροπή του ηλιέλαιου σε ανανεώσιμο ντίζελ

Abstract

dc:description

The transformation of sunflower oil into green diesel has been studied over three series of catalysts. The first series involved nickel catalysts supported on alumina with varying nickel loading in the range (0-100% wt nickel). The second series involved selected non-promoted catalysts of the first series, prepared under slightly different conditions, and corresponding catalysts promoted by small amounts of zinc. The third series involved selected non-promoted catalysts of the first series, prepared under slightly different conditions, and corresponding catalysts promoted by small amounts of cooper. We symbolize the samples with xNiy (Cu or Zn)Al, where x and y stands, respectively, for the percentage composition in nickel and promoter. The catalysts were prepared following a carefully controlled co-precipitation procedure for obtaining the hydroxides of the metals involved from their nitrate salts. The drying of the samples was followed by hydrogenation at 400οC for 2.5 h leading to the formation of alumina and metallic nanocrystals of nickel and the promoter. The catalysts were characterized using nitrogen adsorption- desorption isotherms, XRD, XPS and electronic microscopy (SEM, HRTEM).These were tested for the selective deoxygenation of sunflower oil into hydrocarbons in the diesel range at 310οC and hydrogen pressure of 40bar for various reaction times up to 9h using a semi-batch reactor and a “volume of oil(ml)/mass of catalyst(g)” ratio equal to 100. The products were analyzed using GS and MS.Concerning the first series of catalysts the developed preparative procedure resulted to high specific surface areas mesoporous materials with very small nickel nanocrystals supported on small alumina nanograins providing thus high nickel surface. N-alkanes in the diesel range (n-C17, n-C18, n-C15 and n-C16) are produced whereas intermediate stearic acid and esters of fatty acids have been also detected. Propane, CO, CO2 and CH4 has been also detected in the gas phase. Our experimental observations and literature findings on nickel catalysts allowed proposing a mechanistic scheme for SDO over the catalysts studied. It was concluded that the selective deoxygenation of the natural triglycerides of sunflower oil is mainly proceeds via decarbonylation of the intermediate aldehydes and secondarily by hydrodeoxygenation of the intermediate alcohols. The direct decarboxylation of the intermediate acids cannot be excluded as a minor route. The intermediate esters of fatty acids undergo also SDO. The conversion of sunflower oil and the total yield to hydrocarbons increases with the nickel content up to the sample containing 60%wt nickel and then it decreases. The specific surface area times the surface coverage by nickel, which approaches the nickel active surface, correlates very well with the total yield to hydrocarbons and it is maximized in the aforementioned sample. A total yield to hydrocarbons equal to 61% was obtained over this sample for a reaction time of 9h whereas a complete transformation of the sunflower oil into hydrocarbons is obtained for “volume of oil (ml)/mass of catalyst(g)” ratio equal to 10 and reaction time of 5h. These values correspond to an experiment in a fixed bed reactor working at LHSV = 2h-1. The second series involved the following catalysts: [10NiAl, 9Ni1ZnAl], [20NiAl, 19Ni1ZnAl],[40NiAl,39Ni1ZnAl, 38Ni2ZnAl] [60NiAl, 58Ni2ZnAl, 55Ni5ZnAl]. In all cases the topo chemical composition was found to be very close to the corresponding nominal one. Moreover, we have found quite uniform distribution of Ni, Zn and Al2O3 and increasing porosity at micrometric scale due to the presence of zinc. On the contrary, the texture of the zinc-promoted catalysts at nanometric scale is similar to that of the corresponding non-promoted ones whereas it is not clear a trend of the specific surface area, mean pore size and specific pore volume with the zinc content. The following main crystal phases were detected in the catalysts after drying: aluminum hydroxides, nickel hydroxides, nickel–aluminum mixed hydroxide and zinc oxide. Aluminum hydroxides and mixed hydroxide were transformed respectively upon hydrogenation into aluminum oxide and nickel aluminate. The extent of formation of the mixed phases decreased with the nickel content. The nickel hydroxides and zinc oxide were transformed into monometallic nickel and zinc as well as into a nickel –zinc alloys and mixed crystal phases. Zinc brings about a slight decrease in the nickel dispersion. A portion of nickel and zinc is re-oxidized upon the contact of the pre -reduced catalysts with air, mainly the fine zinc, nickel, Ni-Zn alloy and mixed crystal particles. The zinc promoted catalysts exhibited higher values for the SDO of sunflower oil as they compared to the corresponding non-promoted ones. The promoted action of zinc is maximized in the sample 58Ni2ZnAl with atomic ratio Zn/Ni = 0.033 and it was mainly attributed to electronic nickel–zinc interactions manifested in the Ni-Zn alloy and the crystal phases. The promoting effect was, secondarily, related to the increase of porosity of the samples at micrometric scale due to the presence of zinc.The third series comprised the following catalysts [10NiAl, 9Ni1Cu Al], [20NiAl, 19Ni1CuAl],[40NiAl,39Ni1CuAl, 38Ni2CuAl] [60NiAl, 58Ni2CuAl, 55Ni5CuAl]. The specimens exhibited quite uniform distribution of Ni, Cu and Al2O3 at micrometric scale and the topo chemical composition was very close to the corresponding nominal one. It seems that cooper increases porosity at micrometric scale. In contrast, the texture of the promoted catalysts at nanometric scale is not considerably different compared to that of the corresponding non- promoted catalysts though in the former it is somewhat more complicated in the range of small nanopores. However, one cannot extract a clear trend for the specific surface area, mean pore size and specific pore volume with the cooper content. Aluminun hydroxides, nickel hydroxides, nickel–aluminum mixed hydroxide and cooper oxide were detected in the specimens after drying. Aluminum hydroxides were transformed into aluminum oxide upon hydrogenation and the mixed hydroxide into nickel aluminate. The extent of formation of the aforementioned mixed phases decreased with the nickel content. The nickel hydroxides and cooper oxide were transformed into monometallic nickel and cooper as well as into a nickel –copper alloy. The alloying extend depends on the Cu/Ni ratio and it is maximized in the sample 58Ni2CuAl. It was, moreover, found that the presence of cooper promotion leads to the increase of nickel dispersion and nickel –copper alloy. A portion of nickel and cooper is re-oxidized upon the contact of the pre -reduced specimens with air, mainly the fine copper, nickel and alloy particles. The cooper promoted samples exhibited higher values for the SDO of sunflower oil compared to the corresponding non-promoted ones. The promoted action of cooper is maximized in the sample 58Ni2CuAl with atomic ratio Cu/Ni = 0.04 which exhibited the maximum alloying. Thus, this promoting action was mainly attributed to electronic nickel –cooper interactions manifested in the Ni-Cu alloy which would affect the adsorption of critical intermediates and consequently the rate of slow mechanistic steps of the SDO of sunflower oil. The cooper promoting action was, moreover, related to the increase of nickel dispersion and porosity at micrometric scale due to the presence of cooper.

Degree

thesis:*
Grantor dc:publisher
University of Patras
Year dc:date
2016

Author and committee

dc:creator, dc:contributor.*
Authors dc:creator
  • Gousi, Mantha
  • Γούση, Μάνθα

Subjects

dc:subject × 16

Rights

Language dc:language
gre

Identifiers

dc:identifier.*
Identifier
10.12681/eadd/37103

Chain of custody

source
Harvested from
Greek National Archive of PhD Theses
Base URL
phdtheses.ekt.gr/eadd_oai/request
Last updated
2026-11-18
Source record
OAI-PMH GetRecord
citation

Gousi, Mantha; Γούση, Μάνθα. Επίδραση της σύστασης και της τροποποίησης με Zn ή Cu νανοδομημένων καταλυτών Ni/Al2O3 στη δραστικότητα τους για τη μετατροπή του ηλιέλαιου σε ανανεώσιμο ντίζελ. University of Patras, 2016. http://hdl.handle.net/10442/hedi/37103