Aristotle University Of Thessaloniki (AUTH)
Ανάπτυξη και μελέτη λεπτών υμενίων και κατασκευή οργανικών φωτοβολταϊκών διατάξεων
Abstract
dc:descriptionIn this dissertation organic thin films were prepared and studied. These films were used for the fabrication of Organic Photovoltaics (OPVs). The main study was focused on the photoactive layer which consists of a blend of two organic semiconductors. Much attention was given to the study of the photoactive layer morphology which defines the generation, transport and collection of charges from the electrodes, parameters which define also OPV Power Conversion Efficiency (PCE). As a photoactive layer the blend of polythiophene:fullerene (P3HT:PCBM) was mainly used. Firstly the effect of solvent on thin film morphology was studied. When high boiling point solvents were used it was found that during the slow drying process the blend molecules rearrange into a more thermodynamically favorable semicrystalline state. This process was enhanced by thermal annealing during which a vertical phase separation between the blend components took place with the percentage of the lower free energy component (P3HT) increasing at the film surface. This phase separation results in a morphology which is not appropriate for charge collection in OPVs. Then micorphase separation which can take place in P3HT:PCBM thin films with PCBM crystallization was studied. Moreover the development of P3HT:PCBM thin films from a low boiling point solvent was investigated. In this case during the deposition process by spin coating the polymeric mixture was frozen into a disordered state which permitted better control of film morphology during subsequent thermal annealing. After the optimization of annealing conditions (time and temperature) the devices showed excellent electrical characteristics with high short circuit current densities (10-11 mA/cm2), high fill factors (~58 %) and PCE values up to 3.75 %. The effects of the hole transport layer, (HTL) PEDOT:PSS physical properties on the P3HT:PCBM morphology and its influence on OPV performance were investigated. A clear correlation between the surface free energy of the HTL substrate and the vertical composition profile within the active layer was established. P3HT surface enrichment and PCBM segregation at the bottom interface, were promoted when the BHJ was deposited onto more hydrophilic PEDOT:PSS substrates. Then new semiconducting materials such as fullerene derivatives acting as electron acceptors and polycarbazole derivatives acting electron donors were tested. The system P3HT:ICBA gave higher PCE (up 4.30 %) due to the higher LUMO energy lever of ICBA. Moreover electron donors PCDTBT and Si-PCPDTBT were combined with electron acceptor PC70BM and showed PCE of 3.1 %. Finally the probability to use conducting polymer PEDOT:PSS as an electrode in replacement of the inorganic Indium tin oxide (ITO) was tested. Devices fabricated with PEDOT:PSS electrodes exhibited good electrical characteristics with main disadvantages the increased series resistance and lower short circuit current. In conclusion, in the present dissertation the effect of experimental parameters such as the solvent and the conditions of thermal annealing on the morphology and structure of various polymer-fullerene systems was studied. At the same time functional OPVs were fabricated and studied. The correlation of thin films morphology with the device electrical response resulted to the fabrication of OPVs with high PCE.
Degree
thesis:*- Grantor dc:publisher
- Aristotle University Of Thessaloniki (AUTH)
- Year dc:date
- 2013
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Karagiannidis, Panagiotis
- Καραγιαννίδης, Παναγιώτης
Subjects
dc:subject × 16- Οργανικά φωτοβολταϊκά
- Ανάπτυξη λεπτών υμενίων
- Μικροσκοπία ατομικών δυνάμεων
- Αγώγιμα πολυμερή
- Organic photovoltaics
- Thin films growth
- Atomic force microscopy (AFM)
- Conducting polymers
- Φυσικές Επιστήμες
- Φυσική
- Επιστήμες Μηχανικού και Τεχνολογία
- Νανοτεχνολογία
- Natural Sciences
- Physical Sciences
- Engineering and Technology
- Nano-Technology
Rights
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/37761