National Technical University of Athens (NTUA)
Βελτιώσεις στην προληπτική συντήρηση μηχανολογικού εξοπλισμού
Abstract
dc:descriptionIn this research, we investigate the impact of particle contaminants in the lubrication grease on the operational life of bearings. For this purpose a test rig was developed where rolling bearings were tested. The bearings were filled with pre-contaminated grease using particles of different sizes and hardness. Two types of particles were used, steel particles with 700HV hardness and corundum/alumina (AL2O3) particle with hardness of 2.000HV, in four different particle sizes with average sizes 68μm, 81μm, 96μm και 141μm respectively. In order to monitor the condition of the bearings, a vibration monitoring and measuring rig was developed consisted by two triaxial accelerometers and the necessary electronic equipment (amplifiers, data acquisition machines, PCs). The results from the measurements were collected, processed and plotted in the time domain and in the frequency domain. At the end, the final results were verified with visual inspection using a stereoscope. In the cases were the measuring results indicated the presence of a failure (due to excess vibration levels), these faults were correlated with the visual findings. The results showed a different behavior for the examined contaminants. In the experiments with the harder corundum particles the useful operational life is much shorter than the expected, counting only to 1/10th of it. Vibration levels were higher, above the accepted limits, due to high wear and deformation of the raceways. Wear seems to be independent from the initial size of the contaminants and it is determined from the ultimate fragmentation size of them as they are crushed down to smaller particles. In the case of the softer contaminants from steel, wear is lower and the useful life of the bearings approaches the theoretically calculated. Wear mechanism is different as the ductile contaminants are deformed plastically in order to fit in the load zone. Depending on their initial size, this deformation can be enough to pass through this zone due to the bearing clearance. In the case where larger particles (with average size of 141μm) were used, adhering phenomena and high temperatures were observed due to insufficient lubrication. The current calculation methodology overestimates the nominal life bearings operating with contaminated lubricant and factors such as the size and the hardness of particle contaminants should be taken into account.
Degree
thesis:*- Grantor dc:publisher
- National Technical University of Athens (NTUA)
- Year dc:date
- 2014
Author and committee
dc:creator, dc:contributor.*- Authors dc:creator
-
- Stathis, Antonios
- Στάθης, Αντώνιος
Subjects
dc:subject × 20- Προληπτική συντήρηση
- Έδρανα κύλισης
- Διάγνωση κατάστασης
- Ανάλυση ταλαντώσεων
- Φθορά
- Εκτίμηση υπολειπόμενης διάρκειας ζωής
- Λιπαντικά
- Ρύποι
- Preventive maintenance
- Rolling bearings
- condition monitoring
- Vibration analysis
- Wear
- Residual useful life estimation
- Lubricants
- contaminants
- Επιστήμες Μηχανικού και Τεχνολογία
- Επιστήμη Μηχανολόγου Μηχανικού
- Engineering and Technology
- Mechanical Engineering
Rights
- Language dc:language
- gre
Identifiers
dc:identifier.*- Identifier
- 10.12681/eadd/38084